Disclaimer Information in this document is subject to change without notice. The material contained herein is supplied without representation or warranty of any kind. The seller therefore assumes no responsibility and shall have no liability of any kind arising from the supply or use of this document or the material contained herein. Trademarks All trademarks mentioned in this document may be the property of their respective owners. November 3, 2003 Rev.20 Safety Instructions For Installation •

They currently use analog cellular or standard phone lines to connect in circuit- switched mode for data transfer. Analog cellular phone service is being discontinued. The combination of the Host RJ-11 IP Gateway, RJ-11 IP Gateway, and the AirLink Raven-E enables remote connectivity between host applications and these remote devices over cellular packet data networks. The RJ-11 IP Gateway provides the bridge between a device requiring an RJ-11 interface and the Raven-E, with its Ethernet interfa

August 9, 2001 Information in this document is subject to change without notice. . Copyright AirLink Communications, Inc, 1993-2001. All rights reserved. Please send comments to: email: pubs@AirLink.com Fax: 510-226-4299 Phone: 510-226-4200 Post: AirLink Communications, Inc. Attention: Technical Publications Dept. 472 Kato Terrace Fremont, CA 94539 AirLink Tech Support can be reached at 510-226-4200 Mon-Fri 9:00a-5:00p Pacific Time. Copyright . 2001 AirLink Communications, Inc. All Rights Reserv

Starting the Setup Wizard manually on Windows PCs After one minute, if the Setup Wizard does not run automatically, follow these steps: 1. Double-click the My Computer icon located on the desktop. 2. Double-click the icon that corresponds to your CD-ROM drive, then double-click Setup.exe. 3. Follow the onscreen instructions. First computer only: After the Setup Wizard completes, the BROADBAND LINK indicator light on the front of the HomePortal flashes green as it attempts to establish a connecti

8. In the Power Save Mode field, verify that the CAM (Constantly Awake Mode) radio button is selected (this is the default). 9. In the Network Type field, verify that the Infrastructure radio button is selected (this is the default). 10. Select the Network Security tab. In the WEP field, select the Use Static WEP Keys radio button. 11. In the WEP Key Entry Method field, verify that the Hexadecimal (0-9, A-F) radio button is selected. 12. In the WEP Key 1 field, select the Transmit Key radio butt

Firewall Tab • In the Applications panel, click the Add a new user-defined application link to open the Edit Application page. Figure 18. Edit Application Page Firewall Tab 1. In the Application Name field, enter a name for the application profile. You can enter any name you like, although it’s recommended that you use the name of the application (for example, Redwing Game Server). 2. In the Definition panel, create a definition for your application. A definition consists of a series of protocol

E.g. Internet • TACACS+: for ease of management security administration • Layer 2 and Layer 3 ACL • Port MAC address security options Small Form Factor • Standalone switch for remote locations or where stacking is not required • Silent operation (fanless) Allied Telesis Datasheet | Switches AT-8000S/16 Layer 2 Managed Fast Ethernet Switch AT-8000S/16 16 port standalone 10/100TX Layer 2 switch with 1 active SFP bay (unpopulated) and 1 standby 10/100/1000T port (RJ-45) Overview The small form fact

All rights reserved. No part of this publication may be reproduced without prior written permission from Allied Telesis, Inc. Microsoft and Internet Explorer are registered trademarks of Microsoft Corporation. Netscape Navigator is a registered trademark of Netscape Communications Corporation. All other product names, company names, logos or other designations mentioned herein are trademarks or registered trademarks of their respective owners. Allied Telesis, Inc. reserves the right to make chan