Votos - 3, Puntuación media: 3
(
)
)
|
Resumen del manual
Then re-adjust screw (#6) again to obtain the optimal cutting depth. A knife that is set too low can inflict damage not only to the cutting stick, but also to the knife and the knife drive system. The cutting stick (#2) is inserted into the machine table and fixed by hooking it into a pin located on the left between the knife guide plates. Lubrication IMPORTANT – Before removing any machine covers for service or maintenance, always disconnect machine from power supply. From time to time all moving parts have to be oiled or greased. Before lubricating clean all parts and ensure that they are free of paper dust and dirt. The following parts have to be lubricated: 1. The guide grooves and all other moving parts of the clamp assembly. 2. The knife carrier guide channels (left and right). They are located between the knife guide plates. 3. All moving parts of the knife drive system. To reach these parts, the lower machine cover (#9) and / or the front table (#13) must be removed. 4. The back gauge spindle, its housing points, and the back gauge guide mechanism. The lubrication chart indicates all points to which “EP” grease or oil must be applied A full lubrication of the machine is recommended at least once in every third knife change. Wiring diagram A wiring diagram for the machine is included in the electric switch box, which can be reached by removing the front table (#13). Troubleshooting Should the machine cut out during operation, check the thermal overload switch (#10). If the button of the thermal overload switch has popped out, it can be re-set after a short cooling period. Should the thermal overload switch pop out again and cannot be re-set even after a few minutes, please contact your service technician. If the operator should detect any potentially dangerous defects, he should immediately call a service technician and put the machine out of operation. If defects or faults should occur which render repairs necessary, please contact your local dealer. ...
Otros modelos de este manual:Trituradora, - Ideal Cutter 4810 (75.77 kb)
Trituradora, - Ideal Cutter 4810-11 (75.77 kb)
Trituradora, - Ideal Cutter 5210 (75.77 kb)
Trituradora, - Ideal Cutter 4810 (75.77 kb)