Votos - 1, Puntuación media: 4
(
)
)
|
Resumen del manual
Refill the tank if the fuel level is low. Do not fill above the base of the filler neck. Gasoline is highly flammable and explosive. You can be burned or seriously injured when handling fuel. Stop the engine and keep heat, sparks, and flames away. Handle fuel only outdoors. Wipe up spills immediately. Refuel in a well-ventilated area before starting the engine. If the engine has been running, allow it to cool. Refuel carefully to avoid spilling fuel. Do not fill the fuel tank completely. Fill tank to approximately 1.4 inch (35 mm) below the top of the fuel tank to allow for fuel expansion. It may be necessary to lower the fuel level depending on operating conditions. After refueling, tighten the fuel tank cap securely. Never refuel the snowblower inside a building where gasoline fumes may reach flames or sparks. Keep gasoline away from appliance pilot lights, barbecues, electric appliances, power tools, etc. FUEL TANK TOP MAXIMUM FUEL LEVEL 35 mm (1.4 inch) FUEL TANK CAP FUEL GAUGE FUEL INLET (equipped type) SERVICING YOUR SNOWBLOWER Spilled fuel is not only a fire hazard, it causes environmental damage. Wipe up spills immediately. Fuelcandamagepaintandplastic.Becarefulnottospillfuelwhen fillingyourfueltank.Damagecausedbyspilledfuelisnotcovered underwarranty. FUEL RECOMMENDATIONS These engines are certified to operate on unleaded gasoline with a pump octane rating of 86 or higher. You may use regular unleaded gasoline containing no more than 10% Ethanol (E10) or 5% Methanol by volume. In addition, Methanol must contain cosolvents and corrosion inhibitors. Use of fuels with content of Ethanol or Methanol greater than shown above may cause starting and/or performance problems. It may also damage metal, rubber, and plastic parts of the fuel system. Engine damage or performance problems that result from using a fuel with percentages of Ethanol or Methanol greater than shown above are not covered under warranty. Never use stale or contaminated gasoline or an oil/gasoline mixture. Avoid getting dirt or water in the fuel tank. SERVICING YOUR SNOWBLOWER ENGINE OIL LEVEL CHECK Check the engine oil level with the engine stopped and in a level position. 1. Remove the oil filler cap/dipstick and wipe it clean. 2. Insert and remove the dipstick without screwing it into the filler neck. Check the oil level shown on the dipstick. 3. If the oil level is low, fill to the edge of the oil filler hole (HS928, HS 1132), or upper limit mark (HS724) with the recommended oil (page 42 ). 4. Reinstall the oil filler cap/dipstick. UPPER LIMIT OIL FILLER CAP/DIPSTICK HS928/HS1132: HS724: UPPER LIMIT LOWER LIMIT UPPER LIMIT OIL FILLER CAP/DIPSTICK Runningtheenginewithalowoillevelcancauseenginedamage.This typeofdamageisnotcoveredbytheDistributor’s Limited Warranty. SERVICING YOUR SNOWBLOWER ENGINE OIL CHANGE Drain the oil while the engine is still warm to assure rapid and complete draining. 1. Place the snowblower on a level surface. If your snowblower is the track type, use the foot pedal (page 14 ) to raise the engine. 2. Place a suitable container below the engine to catch the used oil, then remove the oil filler cap/dipstick and the drain plug. HS1132 ONLY: To avoid loosening the drain plug extension, hold it with a 17 mm wrench while loosening the drain plug with a 10 mm wrench. HS1132: DRAIN PLUG EXTENSION HS724/HS928: DRAIN PLUG/ SEALING WASHER DRAIN PLUG/ SEALING WASHER 3. Allow the used oil to drain completely, then reinstall the drain plug with a new sealing washer, and tighten it securely. Improperdisposalofengineoilcanbeharmfultotheenvironment. Ifyouchangeyourownoil,pleasedisposeofusedmotoroil properly.Putitinasealedcontainer,andtakeitarecyclingcenter. Donotthrowitinthetrash,pouritontheground,orpouritdowna drain. SERVICING YOUR SNOWBLOWER 4. If the oil level is low, fill to the edge of the oil filler hole (HS928, HS 1132), or upper limit mark (HS724) with the recommended oil (page 42 ). HS928/HS1132: HS724: UPPER LIMIT UPPER LIMIT Runningtheenginewithalowoillevelcancauseenginedamage. ThistypeofdamageisnotcoveredbytheDistributor’s Limited Warranty. 5. Screw in the oil filler cap/dipstick securely. ENGINE OIL RECOMMENDATIONS Oil is a major factor affecting performance and service life. Use a 4-stroke automotive detergent oil. SAE 5W-30 is recommended for general use. The SAE oil viscosity and service classification are on the API label on the oil container. Honda recommends that you use API SERVICE category SJ or later (or equivalent) oil. AMBIENT TEMPERATURE .. .. 43 SERVICING YOUR SNOWBLOWER HYDROSTATIC TRANSMISSION FLUID TRANSMISSION FLUID RESERVOIR UPPER LIMIT LOWER LIMIT Check the hydrostatic fluid level in the reservoir. At temperatures below 20 °C ( 4 °F), fluid may not be visible in the reservoir before operation, but should rise into the reservoir when the transmission warms up. Hydrostatic fluid expands and contracts with changes in temperature. The UPPER and LOWER limit marks on the reservoir are calibrated for room...
Otros modelos de este manual:Quitanieves - 00X317677230 (3.92 mb)
Quitanieves - HS724-HS928-HS1132 (3.92 mb)
Quitanieves - SZBF-1004437 (3.92 mb)