Votos - 3, Puntuación media: 3.7
(
)
)
|
Resumen del manual
4. When selecting the antenna site, you must consider the structural characteristics of the building. Installation on the edge of rooftops or buildings and on cylindrical structures could lead to increased wind loads and vibration stress according to DIN 1055, part 4, or DIN 4131. Non-observance of these instructions may cause exceeding of the load limit or the vibration resistance. 5. Do not install the antenna on buildings with easily in ammable materials as rooftop, such as straw, reed or similar materials. 6. Only step on rm, dry rooftops and protect yourself against falling down. 7. Ladders, scaffoldings, safety belts etc. must be in good order. 8. Passers-by must not be endangered by falling objects. Secure the work/danger area. 9. Mind that the technical values (e.g. wind load) of the antenna mast are not exceeded. Refer to the manufacturer if you do not know these values. Find an overview of the masts offered by Kathrein on the last page. 10. Mount the antenna mast on solid ground only (walls, concrete, rafters) using the clamps, dowels and screws recommended by the manufacturer. 11. Immediately leave the roof in case of a thunderstorm! 12. Ground the antenna installation according to EN 50083-1. Notice: The OLYMPIA UHF antennas were designed solely for the limited purpose of receiving terrestrial TV signals and as indoor antennas. Under the terms of DIN 4131, an antenna is reckoned an indoor antenna if the mast length does not exceed 6 metres and if the torque needed for screwing the antenna is at 1,650 Nm at maximum. Mast installation and mast calculation (Fig. 1) -Make sure that the mast is in vertical position when mounting it - Only use masts or standpipes specially designed for antenna installation. Other tubes mostly do not have the necessary stability to withstand heavy wind or other climatical situations. Kathrein-masts and clamps ful l these requirements. Find an overview of the masts provided by Kathrein on the last page -The clamping range of the mast clamp of the OLYMPIA antennas is from 22 mm to 60 mm -If the mast is to be mounted on a roof, you have to clamp at least 1/6 of its length -Mind that the mast holders (e.g. clamps) are mounted on solid ground (wood, concrete, walls) 935.543/ *) On buildings higher than 20 stories, a dynamic pressure of 1100 Nm . is considered. Installing several antennas on one mast Never exeed the maximum load capacity of the mast or clamps when mounting several antennas on the mast. Antenna installation (Fig. 2) 1. If necessary, plug together the antenna parts, and x them using wing screws. 2. Fix the dipole with cable connection box on the antenna square pipe using a knurled screw. 3. Open the re ector grille and x it with the wing screws through the antenna square pipe. 4. For the types AOS 32, AOS 65 and AOT 65 place the bow- boom on the marked positions and af x rmly using the provided butterly nuts. 5. Open up the mast clamp and af x the antenna to the mast. Primarily, only screw down the ...
Otros modelos de este manual:receptores de satélite - AOS 32 (413.73 kb)
receptores de satélite - AOS 65 (413.73 kb)
receptores de satélite - AOT 65 (413.73 kb)