Votos - 1, Puntuación media: 3 ( )

Fabricar: GE Monogram Tamaño del archivo: 485.36 kb Nombre del archivo: Idioma del manual:

• Try a liquid detergent. • Use warmer water temperature. Overloading • Load clothes no higher than the top row of holes in the washer basket. • Make sure load size selected matches clothes load size. Incorrect use of fabric softener • Check fabric softener package for instructions and follow directions for using dispenser. Pilling Result of normal wear on poly-cotton blends and fuzzy fabrics • While this is not caused by the washer, you can slow the pilling process by washing garments inside out. Snags, holes, tears, rips or excessive wear Pins, snaps, hooks, sharp buttons, belt buckles, zippers and sharp objects left in pockets • Fasten snaps, hooks, buttons and zippers. • Remove loose items like pins, objects in pockets and sharp buttons. • Turn knits (which snag easily) inside out. Undiluted chlorine bleach • Check bleach package instructions for proper amount. • Never add undiluted bleach to wash or allow clothes to come in contact with undiluted bleach. Chemicals like hair bleach or dye, permanent wave solution • Rinse items that may have chemicals on them before washing. Wrinkling Improper sorting • Avoid mixing heavy items (like work clothes) with light items (like blouses). • Try a fabric softener. Overloading or incorrect water level • Load your washer so clothes have enough room to move freely with water covering all of the clothes. Incorrect wash and dry cycles • Match Cycle selection to the type of fabric you are washing (especially for easy care loads). Repeated washing in water that is too hot • Wash in warm or cold water. 13 Consumer SupportTroubleshooting Instructions Operating Instructions Safety InstructionsConsumer Support Troubleshooting Tips Before you call for service… NOISE Possible Causes What To Do Washer is noisy Washer is uneven • To level the front of the washer, adjust the front leveling legs by rotating the individual leg in the proper direction for up or down. To level back of washer, lift back of machine 4. (11 cm) and set down. Washer load is unbalanced • Push the Cycle knob in to stop the washer, open the lid and redistribute the load evenly. Close the lid and restart. Shipping rod is still assembled in unit • To remove shipping rod from washer, pull yellow tag and attached rod from the bottom right hand side of washer. Washer is sitting too close to wall (causes knocking during cycle) • Pull washer away from the wall; about 4. (11 cm) is needed. Whistle or knock during fill • Normal sounds during fill include the water filling in through the house plumbing. As the water pressure goes up and down, a knock or hammer can develop. Make sure the water faucets are fully turned on. Clanking or clunking • Many washers have features such as pulse agitation and pauses during rinse and spin for reduced clothes wear and to reduce likelihood of soap residue. These short pauses of less than 1 minute are normal and will reduce clothing wear and increase water extraction. Sounds such as a metallic knock, double knock or metallic clunk occur when the washer transitions from a stop or paused state to running or spinning. They occur several times per cycle after speed changes or pauses. • Normal sounds during fill include the sound of water fl...

Descargar ahora

Introduzca dos números de la imagen: