Votos - 6, Puntuación media: 4.3
(
)
)
|
Resumen del manual
The time to charge the capacitor with no clothes load is listed: FABRIC SELECTION CHARGE TIME Heavy 11.5 Minutes Cotton 5.5 Minutes Permanent Press 5.5 Minutes Delicate 5.5 Minutes Page 30 Automatic Computerized Drying Control LED DISPLAY MESSAGES LED DISPLAY MESSAGES Display Condition “__0” load. Normal display between loads. Dryer is waiting for the next “012” timed mode. Normal display during drying/ cooling cycle. Display shows “time used” when in automatic and “time remaining” when in “012” (Flashing) The door has been opened. Close the door and press START to continue the cycle. “-S-” (Flashing) The dryer is in the Safety Tumble mode. The cycle has ended and the dryer can be unloaded. “_PF” (Flashing) There has been a power failure. To restart the dryer, press ON and START. To terminate the cycle press OFF/STOP. “FFF” (Flashing) The temperature sensor has failed. The dryer cannot be run until it is repaired. “-A-” Indicates the automatic mode has been selected. (DRYING TIME and COOLING TIME only). Page 31 Automatic Computerized Drying Control ON OFF/STOP START COOLING TIME DRYING TIME DRYING TEMPERATURE FABRIC SELECTOR OPERATION OF CONTROL PANEL (See drawing on page 33) 1. ON Turn the control on. If dryer is not used for 30minutes, the power will turn off. Press “on” for power. 2. OFF/STOPTurns the control off or stops the dryer during acycle. 3. START Starts the cycle or re-starts it off. 4. COOLING TIME In timed mode, with this button held down, the set cooling time in minutes will be shown in the display. To change the time, use the “up” and “down” buttons while cooling time button is down. The cooling time cannot be changed when automatic cooling is selected, “-A-” will show in the displaywhen this button is held down.) 5. DRYING TIME In timed mode, with this button held down, the set drying time in minutes will be shown in the display. To change the time, use the “up” and “down” buttons while holding “drying time” down. The drying time cannot be changed when automatic drying is selected, “-A-” will show in the displaywhen this button is held down.) 6. DRYING TEMPERATURE With this button held down, the drying temperaturein degrees F will be shown in the display. To changethe temperature, use the “up” and “down” buttons. The drying temperature cannot be changed whenautomatic drying is selected, the temperatureassociated with the fabric selected will show in the display when this button is held down. 7. FABRIC SELECTOR Used to select the type of fabric to be dried whenAutomatic Drying is selected. The fabric selection automatically sets the temperature: HEAVY .................................................. 195.F COTTON ............................................... 195.F PERMANENT PRESS .......................... 175.F DELICATE ............................................ 160.F Page 32 Automatic Computerized Drying Control DRYING COOLING REPEAT LAST CYCLE NON-REVERSING/ REVERSING LED DISPLAY DRYING COOLING END OF CYCLE OPEN DOOR OPERATION OF CONTROL PANEL (continued) (See drawing on page 33) 8. DRYING Pressing this button changes the selection of automatic or timed drying, indicated by a light. 9. COOLING Pressing this button changes the selection of automatic or timed cooling, indicated by a light. In auto coolingmode, the cycle will end when the temperature fallsbelow 135°F. 10. REPEAT LAST CYCLE Pressing this button before the start of a cycle will reset all of the selections, temperatures, and times to whatthey were at the beginning of the last cycle. Press 11. NON-REVERSING/REVERSING Pressing this button changes the selection of Non- reversing and Reversing. 12. LED DISPLAY Shows cycle time or temperature. In automatic mode, it shows the time used. In timed mode, it shows the time remaining. When the DRYING TEMPERATURE button is pressed and held down, the drying temperature will be displayed. When the DRYING TIME button is pressed and held down, either the total drying time or “-A-” will be displayeddepending on whether auto or timed drying has beenselected. When the COOLING TIME button is pressed and held down, either the total cooling timeor “-A-” will be displayed depending on whether auto or timed cooling has been selected. 13. DRYING Illuminated when in the drying cycle. 14. COOLING Illuminated when in the cooling cycle. 15. END OF CYCLE Illuminated at the end of the cycle. 16. OPEN DOOR Illuminated when the door is open. START must be pressed to restart the cycle after closing the door. Page 33 Automatic Computerized Drying Control Panel (Illustration) Page 34 Automatic Computerized Drying Control DETAILS OF CONTROL BOARD AND OPTIONS OPTIONS SWITCH SET #1 Switch ON OFF #8 F/C Deg F Deg C #7 SFTY-EN Enabled Disabled #6 6-Add + 6 Min. 0 #5 Repeat S/E Start End #4 2 Deg. + 2 Deg. 0 #3 5 Deg. + 5 Deg. 0 #2 10 Deg. + 10 Deg. 0 #1 20 Deg. + 20 Deg. 0 #8 F/C Selection of Deg F or Deg C for temperature display. #7 SFTY-EN The switch enables the “safety tumble” feature. To disable, position th...
Otros modelos de este manual:Secadoras - L36URD36G (341.47 kb)
Secadoras - L36URD36E (341.47 kb)
Secadoras - L36URD36S (341.47 kb)
Secadoras - L36URS36E (341.47 kb)