Votos - 5, Puntuación media: 4
(
)
)
|
Resumen del manual
2. Install the batteries as shown in the battery compartment. 1. Turn the transmitter face down. Press and slide off the battery 3. Replace the cover and slide in reverse until the lock snaps. (Polarity + or – must match the markings in the compartment.) “AA” size cover. + + - - Helpful Hint: For frequent remote control users, replace old batteries with Alkaline batteries for longer life. Precaution on battery use Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter. Disposal of batteries should be in an environment-friendly manner. Observe the following precautions: 1. Batteries should always be replaced as a pair. Always use new batteries when replacing the old set. 2. Do not combine a used battery with a new one. 3. Do not mix battery types (example: “Zinc Carbon” with “Alkaline”). 4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries. 5. Battery replacement is necessary when the remote control acts sporadically or stops operating the Plasma Display. 9 Connections 1 2 PC IN SERIAL AUDIO SLOT1 SLOT2 SLOT3 1 2 1 SPEAKERS 2 Terminals (R) SPEAKERS Terminals (L) – Cable fi xing bands Secure any excess cables with bands as required. When connecting the speakers, be sure to use only the optional accessory speakers. Refer to the speaker’s Installation Manual for details on speaker installation. (Example: TH-42PWD8GK) Speakers (Optional accessories) Pass the attached cable fi xing band through the clip as shown in the fi gure. To secure cables connected to Terminals, wrap the cable fi xing band around them then pass the pointed end through the locking block, as shown in the fi gure. While ensuring there is suffi cient slack in cables to minimize stress (especially in the power cord), fi rmly bind all cables with the supplied fi xing band. From SERIAL Terminal on Computer (see page 11) From EXTERNAL monitor terminal on Computer (see page 10) AC cord connection (see page 12) To tighten: To loosen: Pull Pull Push the catch 3. Slide up the clamper and fi x the AC cord plug securely. 2. Insert the AC cord and close the clamper securely. 1. Open the clamper. Clamper AC cord Note: The power plug in the illustration may not be the type fi tted to your set. When loosen the clamper: Note: TH-37PWD8GK/S, TH-37PHD8GK/S have two slots only. – AC cord fi xing 4. Insert the point of the fi xed clamper into the small hole on the lower r i g h t o f the back cover as necessary. Optional Terminal Board Insert Slot (covered) Connections PC Input Terminals connection COMPUTER AUDIO TH-42PWD8 Conversion adapter (if necessary) RGB PC cable Stereo plugAudio Connect a cable which matches the audio output terminal on the computer. Mini D-sub 15p Notes: • Due to space limitations, occasionally you may have trouble connecting Mini D-sub 15P cable with ferrite core to PC input Terminal. • Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical scanning frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.) • The display resolution is a maximum of 640 . 480 dots (TH-37PWD8GK/S, TH-42PWD8GK/S), 768 . 720 dots (TH37PHD8GK/ S), 768 . 768 dots (TH-42PHD8GK/S) when the aspect mode is set to “NORMAL”, and 852 . 480 dots (TH-37PWD8GK/S, TH-42PWD8GK/S), 1,024 . 720 dots (TH-37PHD8GK/S), 1,024 . 768 dots (TH-42PHD8GK/S) when the aspect mode is set to “FULL”. If the display resolution exceeds these maximums, it may not be possible to show fine detail with suffi cient clarity. • The PC input terminals are DDC1/2B-compatible. If the computer being connected is not DDC1/2B-compatible, you will need to make setting changes to the computer at the time of connection. • Some PC models cannot be connected to the set. • There is no need to use an adapter for computers with DOS/V compatible Mini D-sub 15P terminal. • The computer shown in the illustration is for example purposes only. • Additional equipment and cables shown are not supplied with this set. • Do not set...
Otros modelos de este manual:TV - TH-37PHD8GK (4.71 mb)
TV - TH-37PHD8GS (4.71 mb)
TV - TH-42PHD8GK (4.71 mb)
TV - TH-42PHD8GS (4.71 mb)