Votos - 3, Puntuación media: 4
(
)
)
|
Resumen del manual
/ 24 Hr. Time Format 17 Programming Introduction 18 Personal Program Schedule 19 Programming 21 Weekday/Weekend Programming 22 7-Day Programming 25 Everyday Programming 27 Program Options 29 INSTALLATION PROGRAMMING (continued) Programmable Fan 29 System Selection Key 31 Fan Key 31 Reviewing the Current Temperature Setting 32 Temporary Manual Override 33 Permanent Manual Override 34 Vacation (Programmable) Hold 35 Auto Season Changeover 36 Home Today 37 Energy Monitor 39 Filter Monitor 40 SPAN Settings 41 Auto Recovery 42 Keyboard Lock 43 Backlighting (INDIGLO® Night-Light) 44 Low Battery Warning 45 Error Mode 45 Problems & Solution 46 Table of Contents (continued) PROGRAMMING (continued) OPERATIONS Technical Support 47 Technical Support 48 OPERATIONS (continued) TROUBLESHOOTING WIRING DIAGRAMS Read This Before Installing Thermostat IMPORTANT 1Read the entire installation section of this Owner’s Manual thoroughly before you begin to install or operate your Hunter Thermostat. Remove the Mylar label from the LCD display window. INSTALLATION 2All installation is normally performed at your thermostat. ARMCHAIR PROGRAMMING 3You can program your thermostat before installation by inserting the batteries and following the instructions starting on page 16. This can be done while you relax in your favorite chair and is a very good way to familiarize yourself with all the functions of your Hunter Thermostat. SYSTEM COMPATIBILITY 4Your Thermostat is designed to operate with most gas, oil, electric, or 2-wire hot water heating and air conditioning systems. It will also operate single-stage heat pumps that do not have auxiliary or emergency heat. These have 24 volt or millivolt control systems and represent most central heating, air conditioning, or space heating units in the United States. This thermostat will not control 120/240 Volt systems or millivolt systems. COMPRESSOR PROTECTION 5The thermostat provides a 3.5 minute delay after shutting off the heating or cooling system before it can be restarted. This feature will prevent damage to your compressor caused by rapid cycling. TEMPERATURE RANGE 6Your thermostat can be programmed between 45°F and 95°F (7°C and 35°C). However, it will display room temperatures from 15°F to 99°F (-9°C and 37°C). “HI” will be displayed if the temperature is higher than 99°F (37°C), and “LO” will be displayed if the temperature is lower than 15°F (-9°C). AUTO RECOVERY 7Your thermostat is set from the factory to gradually recover the room temperature from an energy saving program to your comfort program. Therefore, the thermostat may turn your system on several minutes prior to your programmed time. This operation is normal, but can be turned off. Refer to the Options Menu information on pages 16. OPERATION 8NOTE: The INDIGLO® Night-Light will not function when the battery power is low. BATTERY WARNING 9Two fresh AA alkaline batteries should provide well over one year of service. However, when the batteries become drained, the Low Battery Indicator will flash on the display. when this message occurs, install new alkaline batteries. You have appoximately one minute to change the batteies and keep the thermostat’s clock and program settings. Once the batteries have become too low to ensure proper operation, your system will be turned off, and the display will be cleared except for the flashing Low Battery Indicator on the LCD display. CAUTION: When only the battery Icon flashes on the display, the display, the thermostat is shut down and your system will no longer operate. In this condition, there is no REMOTE SENSORS (does not apply to thermostat model 44660) 1Your thermostat can support 3 remote sensors that will measure the temperature from three different locations - two indoor and one outdoor. To configure your thermostat to work with the remote sensors, follow the instructions for Sensor Channel selection on page 14 of this manual. To configure the remote sensors, consult the Remote Sensor Instruction Manual. NOTE (does not apply to thermostat model 44660) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipm...
Otros modelos de este manual:Los termostatos - 43665 (771.8 kb)
Los termostatos - 43665 (771.8 kb)