Votos - 1, Puntuación media: 3 ( )

Fabricar: GE Monogram Tamaño del archivo: 2.07 mb Nombre del archivo: Idioma del manual:

When set for ALL 3 element positions the leftrear i (_) A, W element isadded for a total combination of 3 even heating surfaces (See Figures 7 & 8). _ @+Bridge The Bridge element is designed for rectangular or oval shaped cookware. The griddle that is supplied with this appliance should be used with the Bridge element ONLY. For round w Q_j Front shaped cookware, the left front and left rear elements may be used as a single element. Figure 4 To Operate the Bridge Surface Element: Figure 3 1. Place correctly sized cookware on the radiant surface element. 2. Touch and hold the P_'-w_ key pad until a beep sounds. The power indicator light will turn iW (_ All ON. Note: If no key pad is touched within 20 seconds the request to Power ON the cooktop @+Bridge will clear. w @ Front 3. Touch and hold the _i} pad for the Bridge element position until a beep is heard. The Figure 6 display will show" --". Note: If no further pads are touched within 10 seconds the request to power the element ON will clear. Figure 5 4. Select the FRONT (See Figures 3 & 4), +BRIDGE (See Figures 5 & 6) or ALL 3 elements ,,C All (See Figures 7 & 8) to heat by pressing the _!} pad once, twice or three times. When the bridge is set to ALL setting, the display of the left rear element changes to reflect the I @+Bridge same setting as the left front element. w (_}_ Front 5. Touch HI @ pad once to turn ON the power levelto HI. Touch Lo @ pad once for Lo. 6. Each touch of the HI or Lo pad will decrease or increase the power level Figure 7 Figure 8 from 9.5 through 3.0 by .5 increments. Simmer power levels between 3.0 and 1.2 will decrease or increase by .2 increments. Lo is the lowest power level available. Note: The power level may be adjusted at any time while the element is ON. 7. Start most cooking operations on a higher setting and then turn to a lower setting to finish cooking. Each surface element provides a constant amount of heat at each setting. A glowing red surface heating area extending beyond the bottom edge of the cookware indicates the cookware is too small for the surface heating area. J 8. When cooking has been completed touch the (on/of_pad once to turn the element OFF and if no other surface element is used touch the P_-wE'_key pad to turn off he cooktop. Note: The HE (hot element) message will remain ON if the cooktop is still hot and will remain ON until the heating surface area has cooled sufficiently. Radiant surface elements may appear to have cooled after they have been turned off. The glass surface may still be hot and burns may occur if the glass surface is touched before it has cooled sufficiently. Do not place aluminum foil or plastic items such as salt and pepper shakers, spoon holders or plastic wrappings on top of the range when it isin use. These items could melt or ignite. Potholders, towels or wooden spoons could catch fire if p...

Descargar ahora

Introduzca dos números de la imagen: