Votos - 4, Puntuación media: 3.8
(
)
)
|
Resumen del manual
Note: Ensure the circuit breakers for power supply are turned on. Control Panel Operation Controls are located on the back of the unit (see Figure 3). 1. Main ON/OFF Power Switch: This switch is located at the furthest right corner on the control panel when looking at the back of the unit. Turn the switch to ON and unit will be ready to operate. The "|" indicates ON and "O" indicates OFF. IMPORTANT: Once you turn the main switch to the ON position, the remote control can no longer be used. In order to use the remote control, you must keep the main ON/OFF switch in the OFF. 2. Ember Control Dial: There is a divided circle under this dial. After you turn the Main Power switch to the ON position, turn the Ember Control Dial to desired setting. This dial controls the intensity of the lighting under the ember bed. 3. Flame Control Dial: There is a flame picture under this dial. Turn this dial to adjust the flame intensity. 4. Heater Switch and Control Dial: The heater switch has a sun directly below it. To turn the heater on, flip Heater Switch to ON position ( "|" indicates ON and "O" indicates OFF). The Control Dial has a thermometer below it. Turn dial clockwise past the number 8. You should hear a small clicking sound indicating the heater has started and heat will emit through vents located at the top of unit. To turn off heater, turn the temperature dial counter clockwise past number 1 and flip Heater Switch to OFF position. To increase the desired temperature, turn temperature dial clockwise towards Number 8. To decrease desired temperature, turn temperature dial counter clockwise towards number 1. The heater has a built-in thermostat so it will shut off automatically once set temperature is reached. It will also turn on automatically if room temperature drops below the set temperature on dial. Note: When the heater is turned on for the first time, it may release a slight, harmless odor. This odor is a normal occurrence caused by the initial heating of the internal heating elements and should not occur again. (Some odor may occur when dust settles on the unit and is burned off). Operating by remote control 1. Plug in your electric fireplace and it will beep once. This means you have power and your remote is ready to operate your electric fireplace. IMPORTANT: To control the electric fireplace by remote, the Main ON/OFF power switch on the fireplace must be in the OFF position; the remote control will NOT work if the manual ON/OFF switch is in the ON position. Main Power Switch Heater Switch Flame Control Dial Heat Control Dial Ember Control Dial Figure 3 - Electric Stove Control Panel 2. When operating the remote control, it must be pointed at the logset inside the electric stove and a beep must be heard each time you press a function button. The beep confirms the remote control is performing the function you have requested. Note: Make sure your batteries are fully charged and installed correctly in your remote control. 3. POWER ON/OFF button a...
Otros modelos de este manual:Placas - CGESBMRA (718.29 kb)
Placas - CGESBMRA (718.29 kb)
Placas - CGESBMRA (718.29 kb)
Placas - CGESBMRA (718.29 kb)