Votos - 1, Puntuación media: 4
(
)
)
|
Resumen del manual
THE MANUFACTURING FIRM REFUSES ALL RESPONSIBILITY FOR DAMAGES TO PEOPLE, ANIMALS OR OBJECTS, RESULTING FROM THE FAILURE TO COMPLY WITH SUCH PROVISIONS. The appliance is designed to be embedded into heat-resistant cabinetry. Cut a hole in the top of the cabinetry, with the dimensions indicated in fig. 3, at a distance of at least 50 mm from the appliance border to the adjacent walls. WARNING: – The surrounding cabinetry must resist a minimum temperature of 75°C. – The equipment must not be installed near inflammable materials, such as curtains, cloths, etc. ( Ref to Fig. 3 on page 8) MODEL L (mm) P (mm) 600-750 560 490 900 820 490 If the are any over-head cabinets above the cooktop they must be a minimum of 762 mm (30") higher. The distance on the left and on the right side from lateral wall should be at least 110 mm (4.5”), while the distance from the back wall should be at least 25 mm (1”). It is advisable to isolate the appliance from the piece of furniture below with a separator, leaving a depression space of at least 10 mm (fig. 4). If the hob is going to be installed above an oven, precautions must be taken to guarantee installation is in accordance with current accident prevention standards. Pay particular attention to the position of the electric cable and gas pipe: they must not touch any hot parts of the oven. WARNING: If the hob is going to be installed on the top of a built in oven without forced cooling ventilation, proper air vents must be installed to guarantee an adequate ventilation, with the lower air entering with a cross section of at least 200cm2, and the higher air exiting with a cross section of at least 60 cm2. Fastening the top Every cook-top is equipped with a special washer and a set of hooks for mounting the cook-top. Once the cut-out is made in the cabinet surface, the installation procedure is as follows: – Remove the trivets and complete burners from the top. – Turn the appliance upside down and lay the ‘S’ washer along the external border (fig. 5). – Place the cook-top in the hole made in the piece of furniture then block it with the V screws of the fastening hooks G (fig. 6 / 6A). NOTE: This appliance is not provided with a device for exhausting the products of combustion. Please check your local regulations to ensure installation is in conformity. Gas Connection Make sure that the appliance is adjusted for the gas type available in your area (see the label under the appliance). Follow the instructions indicated in the chapter “gas transformations and adjustments” for the possible adaptation to different gases. The appliance must be connected to the gas system by means of still metal pipes or flexible steel pipes having continuous walls, in compliance with the regulations in force in your area. Some models are equipped with cylindrical A and conical B connectors for gas supply (fig. 7). WARNING: The connection must not stress the gas ramp. Electric connection The connection to the electric grid must be carried out ...
Otros modelos de este manual:Placas - CGA 60 WOK (110.53 kb)
Placas - CGA 60 WOK (110.53 kb)
Placas - CGA 60 WOK (110.53 kb)
Placas - CGA 75 WOK (110.53 kb)