Votos - 2, Puntuación media: 4 ( )

Fabricar: Jenn-Air Tamaño del archivo: 2.82 mb Nombre del archivo: Idioma del manual:

Only flat-bottom cookware should be used. The type and size of cookware, the number of surface elements in use and their settings, are all factors that will affect the amount of heat that will spread to Figure 1 areas beyond the surface elements. The areas surrounding the elements may become hot enough to cause burns. About the Radiant Surface Elements The element temperature rises gradually and evenly. As the temperature rises, the element will glow red. To maintain the selected setting, the element will cycle on and off. The heating element retains enough heat to provide a uniform and consistent heat during the off cycle. +9++, Left front Left rear Ri htfront For efficient cooking, turn offthe element several minutes before cooking is complete. This wiltallow residual heat to complete the cooking process. Locations of the Radiant Surface Elements and Controls Your range is equipped with radiant surface burners with 6 different wattage ratings. The ability to heat food quicker and in larger volumes increases as the element wattage increases. The radiant surface elements are located on the cooktop as follows (See Figure 2); a smaller 6 inch radiant element located at the right rear position; a dual 6 or 9 inch radiant element located at the right front position; a Warmer Figure 2 Zone radiant element at the center rear position (See page 12); and two 8 inch radiant elements located at both the left front and rear positions. NOTE: Please read detailed instructions for ceramic glass cooktop Located between left front and rear elements is cleaning in the General Care & Cleaning section and Before You Call checklist section of this Use and Care Guide. a Bridge radiant element. NOTE: Radiant elements have a limiter that allows the element to The BRIDGE radiant element is controlled using cycle on and off, even at the HI setting. This helps to prevent the same knob that controls the left front radiant damage to the ceramic smooth top. Cycling at the HI setting is element position. See pages 10 and 11 for more normal and can occur if the cookware is too small for the radiant information about using BRIDGE radiant element or if the cookware bottom is not flat (Refer to page 11 for element. using correct cookware instructions with the cooktop). Setting Surface Controls FEATURE OVERVIEW General Information on Electronic Surface Element Controls (ESEC) Available ESEC Display Settings Surface Cooking Settings The Electronic Surface Element Control (ESEC) The Electronic Surface Element Control ("ESEC") feature includes 4 digital display windows. The ESEC feature provides a numeric digital setting for 4 of the radiant surface element positions on the cooktop, including shared settings at the left front knob control position for both the left front radiant element and the "Bridge" radiant element. Also the right front control knob position shares settings for the dual radiant element. These settings work the same way as normal knob setting indicator...

Descargar ahora

Introduzca dos números de la imagen: