Votos - 3, Puntuación media: 3.7
(
)
)
|
Resumen del manual
With stronger work tops the aperture has to be enlarged accordingly where the cooker plates are situated. approx partition board or cupboard Ik' T wall wall | ]) If the extension piece of the unit or the control panel is situated on the right, this width can be reduced to 25 minimum. Fig. 4 Minimum distances to surrounding walls. wall Fig. 5 EKMUE 4.77 In case a cupboard with a top is to be fitted underneath the work top (or a stove for that matter) an additional cut out has to be provided to cover the area of the cooker plates. Furthermore, it must be ensured that no inflammable objects or articles which catch fire easily or which are deformable, are placed directly below the cooker plates. . _ =©000© Positioning of the cooker plates in relation to a cupboard or stove to be fitted underneath the unit. Fig. 6 The enclosed durable, elastic and heat-resistant seal strip is to be laid into the hob edge so that only a small overlap remains towards the contact surface (see fig. 7). Before placing the hob unit in the work top the screws of the clamping strip have to be unscrewed (fig. 8 a and 8 b). Afterwards the hob has to be srewed into the work top Please make sure that the work surface and also the hob unit are mounted level. Only then, for instance, will you get equal distribution of Fig. 8 a and 8 b Description of circuit connection for hob and stove, control panel respectively. The circuit connection between the cooker plates and the device which they are being combined with, is provided through flexible plug-contacts (“Wielandstecker“). These plug-contacts are mar- according to figs. 8 a and 8 b. The screw caps which are used to hold the work surface have to be hand tightened only. the fat in the pan, because the cooker plates in themselves are manufactured absolutely level. ked with lines which have to meet up if the parts have been joined together correctly. The earth wires of the cooker plates have to be connected up with the earth wires of the switch strip; to be tightened with the enclosed special screws. Final Adjustment of the Cooker Plates If not already the case, the cooker plates can be made level by finally adjusting them with the adjusting screws (1-2-3) which can be reached from underneath (fig. 9). Connection of two built-in hob unites Fig. 10 SI m 1 Rail to give protection from the top 2 Rail to support the joint from below 3 Screw "M3x 8“ 4 off 4 Seal The built-in hob units should be placed in the aperture side by side. The rail 1 and the seal 4 should be placed between the hobs from the top as indicated in fig. 10. Rail 2 should then be screwed against rail 1 by using screws 3 (4 off). After that the built-in hob units should be tightened as described in the installation instructions. The Connection IMPORTANT: SEE FOOTNOTE ON PAGE 3 AEG electric built-in appliances conform to safety regulations laid out by VDE (“Association of German Engineers“)/CEE. According to these heat ...
Otros modelos de este manual:Placas - EM 4.58 D (1.07 mb)
Placas - EME 4.58 D (1.07 mb)
Placas - EM 4.58 D (1.07 mb)
Placas - EME 4.48 R (1.07 mb)