Upright Type (w/o Flywheel)-- Upright Type (with Flywheel)---------------------------------------- 2. Recumbent Type (EC-3600 & EC-3700)-------------------------- 3. Belt Drive (EC-1200B, EC-1600B, EC-3600B & EC-3700B) Circuit Diagram--------------------------------------------------------------- Part A ® Symptoms of Problems & Causes T-1 T-2 T-3 T-4 T-5 T-6 T-7 No Display on Control Unit after Power ON ■ No Display of Cadence----------------------------- No Display of Pulse Rate

(See the Sections D-1 & D-2 "Removing the Frame Covers.") 2. Detach the CN-3 connector from the power supply board. (Fig. 1) 3. Cut the cable holders which fix the CDC sensor cable to the frame. 4. Remove the defective CDC sensor set by loosening the screws, and mount and fix the brandnew CDC sensor set. (Fig. 2) 5. Perform the following adjustments. (Figs. 3 and 4) © Align the line on the CDC sensor with the center of the line on the CDC magnet. (Fig. 3) © Adjust the gap between the surfa

C-Shape Brace Remove the axle nut and washer from the rear wheel axle. Place the brace stabilizer washer onto the axle and align the washer so that the notch on the washer fits into the rear frame drop out. Next, place the C-shaped wheel brace onto the axle and replace the washer and axle nut. Tighten the axle nut securely, making sure that the wheel brace stays in the proper vertical position. The elongated hole on the wheel brace allows the training wheel height to be adjusted for proper fit.

Please read the manual carefully before using this product. Safeguard the manual along with the warranty card. ENGSymbol marks used for safety precautions in this manual The descriptions accompanying the following symbol marks in this manual refer to very important issues in terms of your safety and handling of the unit. You are strongly urged to observe these precautions carefully. Warning Failure to observe this warning could result in serious injury or death. Caution Failure to observe this w