Votos - 1, Puntuación media: 5 ( )

Fabricar: England's Stove Works Tamaño del archivo: 136.53 kb Nombre del archivo: Idioma del manual:

Do not over-tighten the screws when reinstalling. WARNING: ANY CHANGE TO THIS HEATER OR ITS CONTROLS CAN BE DANGEROUS. WARNING: Failure to position the parts in accordance with this diagram or failure to use only parts specifically approved with this heater may result in property damage or personal injury. MODIFICATIONS TO THIS APPLIANCE MAY CAUSE SERIOUS INJURY OR DEATH. ANY CHANGE WILL VOID THE WARRANTY. WARNING: ANY CHANGE TO THIS HEATER OF ITS CONTROLS CAN BE DANGEROUS. IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. This unit has a piezo ignition pilot. When lighting the pilot, follow these instructions exactly. A. BEFORE LIGHTING, smell around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor. WHAT TO DO IF YOU SMELL GAS 1. Do not try to light any appliance. 2. Do not touch any electrical switch; do not use the phone in your building. 3. Call the gas supplier from a neighbor’s phone. Follow their instructions. 4. Call the fire department if you cannot reach the gas supplier. B. Use only your hand to push in or turn the gas control knob — never use tools. If the knob will not push in or turn by hand, do not attempt to repair it. Call a qualified technician. Force or attempted repair may result in an explosion. C. Do not use the appliance if any part has been under water. Immediately call a qualified service technician to inspect the unit and to replace any of the gas control that has been under water. D. Do not use this appliance for burning trash or cooking. Never place matches, paper, garbage or any other material on top of the logs or in the flame. OPERATING INSTRUCTIONS Pilot Gas and Lighting Procedure 1) Turn off all electric power to unit. Remove control access panel. 2) Set thermostat to lowest setting. 3) Turn knob “A” clockwise to “OFF”. 4) Wait five (5) minutes to clear out any gas. Smell for gas –STOP—follow safety precautions if you do smell gas (If not go to step 6). Find pilot – follow metal tube from gas control. The pilot is between the two burner tubes. 5) Turn knob “A” slightly counterclockwise towards the “IGN” position until it stops. Press down and hold for five seconds (only pilot gas flows). 6) Continue pressing knob “A” down while turning further c/clockwise to activate the piezo. Continue to hold down for ten (10) seconds after pilot light has been lit. If the pilot light does not light, these steps can be repeated immediately. (See note below) Note: If pilot flame is not established, equipment manufacturer (OEM) will determine the number of additional attempts to light – and with continued failure, the purge time required before further attempts. MAIN BURNER IGNITION 1) Upon lighting, release knob and turn further counterclockwise < to “ON” position (both pilot and gas flow). 2) Tu...

Descargar ahora

Introduzca dos números de la imagen: