Votos - 5, Puntuación media: 4.2 ( )

Fabricar: Broan Tamaño del archivo: 574.54 kb Nombre del archivo: Idioma del manual:

Failure to observe these intervals may cause the risk of fire through fat deposition. 40 A = Metal fat filter grille B = Control panel C = Lighting / \ I I [rn < >- o- B Appliance description 41 First use Operation My sliding switches are arranged on the RH side (when viewed below from the front). The individual numbers and symbols have the following meanings (from left to right): ns 5* = Lighting On ofcb = Lighting Off = Lighting -m- = Blower On -m- = Blower Off = Blower setting switch 1 = Blower setting 1 2 = Blower setting 2 3 = Blower setting 3 4 = Blower setting 4 To switch on the fume extractor hood, set my blower switch to the “On” position The blower of the fume extractor hood runs. With the blower setting switch §, you can set the fume extractor hood to the power you require (depending on the amount of fume being generated by the hobs). You can separately switch my workplace lighting (hobs) on or off with the On or Off § switch. 42 DVN1 11/89 - WPF1 11/89 - WKF1 11/89 GB/EU The build-in fume extractor hood is to be switched on before cooking begins and aiiowed to run on around 15 minutes after cooking is completed. You should remove my metal fat filter (Fig. EW) from the appliance every 6 — 8 weeks and wash it by hand or in your dishwasher. The active carbon filter must be changed not later than after 1 year. The active carbon filter cannot be washed or regenerated. Good deodorization is conditional upon a suitable active carbon volume (depending on the air capacity of your fume extractor hood) and specific arrangement of the active carbon filter in your fume extractor hood. This combination ensures a positive return air supply in contrast to exhaust air operation. A decisive factor affecting deodorization is what is known as the dwell time of the aspirated air in the active carbon filter. This dwell time can only be achieved with the AEG Original Active Carbon Filter (see Special accessories) Pre- and after-running of fan Metai fat filter Instructions on active carbon filter. Cleaning the To remove and then clean my metal fat filter grille, proceed as metal fat filter follows: For reasons of safety against any unintentional switching on, remove my screw-in fuse from the holder or switch off my automatic fusing system in the fusebox. 1. Press the lock on the fat filter grille inwards and detach the fat filter at the front and rear. 2. Clean my internal housing only with warm washing-up liquid suds (never use any abrasive cleaners, brushes, or scouring agents). 3. After cleaning, re-insert both dry metal fat filters. 4. Re-insert the fuses and reconnect the appliance. Active carbon To remove and then replace 2 KL 600 carbon filters (E-No. filter 610 899 470) (for your own account from our range of special accessories), proceed as follows: For reasons of safety against any unintentional switching on, remove my screw-in fuse from the holder or switch off my automatic fusing system...

Descargar ahora

Introduzca dos números de la imagen: