Votos - 1, Puntuación media: 3 ( )

Fabricar: Dacor Tamaño del archivo: 285.16 kb Nombre del archivo: Idioma del manual:

Then fasten the strip to the bottom part of the hood with three clips (special accessories). Apply pressure. Fig. 8. Fig. 8 Fitting the carbon filter for filter version If the fume extractor hood is installed as a return air appliance (Filter version - air outlet above the wall unit), the carbon filter (special accessory) must be fitted before the grease filters are fitted. Installation sequence: 1. Insert the holding frame for the carbon filter in the shaft of the hood with the 2 lugs facing upwards and then clip into the lower holes. 2. Fix the holding frame on the lower part of the housing of the hood with the 2 screws supplied. Fig. 9. 3. Fit the carbon filter (see paragraph “Carbon filter”) 4. Refit the grease filters. Push-in the vapour catcher. Fig. 9 Removing the hood from the wall unit If, for technical reasons (extractor version/filter version conversion) the fume extractor hood has to be removed from the wall unit, proceed as follows: • Fully withdraw the vapour catcher and remove the grease filter. • Loosen the 4 or 6 mounting screws of the hood (wall unit mounting). • To loosen both mounting claws (installation aids), place a max 3 mm dia. Phillips screw-driver in the spring opening and simultaneously press the springs inwards (towards the appliance housing). Fig. 10. Important: Hold the hood firmly! Adjusting the extractor part (E - Fig. 1) - Fig. 11 On wall units with a body depth of 275 mm to 335 mm, the vapour catcher depth can be adjusted as follows: • Remove both grease filters. • Loosen the screws on both end-stop brackets and set the vapour catcher depth (min. 275 mm, max. 335 mm). • Refit the screws. • Refit the grease filters. Fig. 10 Fig. 11 Removing the hood from the wall unit If, for technical reasons (extractor version/filter version conversion) the fume extractor hood has to be removed from the wall unit, proceed as follows: • Fully withdraw the vapour catcher and remove the grease filter. • Loosen the 4 or 6 mounting screws of the hood (wall unit mounting). • To loosen both mounting claws (installation aids), place a max 3 mm dia. Phillips screw-driver in the spring opening and simultaneously press the springs inwards (towards the appliance housing). Fig. 10. Important: Hold the hood firmly! Adjusting the extractor part (E - Fig. 1) - Fig. 11 On wall units with a body depth of 275 mm to 335 mm, the vapour catcher depth can be adjusted as follows: • Remove both grease filters. • Loosen the screws on both end-stop brackets and set the vapour catcher depth (min. 275 mm, max. 335 mm). • Refit the screws. • Refit the grease filters. Fig. 10 Fig. 11 Installing the front panel (see also “Special accessories”) • Remove first the rear then the front grease filters. • Remove the internal cover pressing both unlocking devices (press and pull). Fig. 12. • Predrill the front panel as per template and fix it to the vapour catcher with 3 screws. Fig. 13-14. • Clip the Internal cover back in and insert both grease filters (first the ...

Descargar ahora

Introduzca dos números de la imagen: