Votos - 1, Puntuación media: 3
(
)
)
|
Resumen del manual
The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared. The control switches are located on the unit’s front panel: Light switch Speed 3 Speed 2 Motor switch Speed 1 • the light switch switches the hood lamp on and off • the motor switch switches the motor off • Speed 1: Speed 1 push-button • Speed 2: Speed 2 push-button • Speed 3: Speed 3 push-button Maintenance and Care Warning! Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. Metal grease filter • The purpose of the grease filters is to absorb grease particles which form during cooking and it must always be used, either in the external extraction or internal re-circulation function. Attention: the metal grease filters must be removed and washed, either by hand or in the dishwasher, every four weeks. Removing the metal grease filters • Push it towards the back of the unit and then pull it down and out. Fig. 3. Hand washing Soak grease filters for about one hour in hot water with a grease- loosening cleaner, then rinse off thoroughly with hot water. Repeat the process if necessary. Refit the grease filters when they are dry. Dishwasher Place grease filters in the dishwasher. Select most powerful washing programme and highest temperature, at least 65°C. Repeat the process. Refit the grease filters when they are dry. When washing the metal grease filter in the dishwasher a slight discolouration of the filter can occur, this does not have any impact on its performance. • Clean the inner housing using a hand hot solution only(never use caustic detergents, abrasive powders or brushes). Fig. 3 Charcoal filter • The charcoal filter should only be used if you want to use the hood in recirculation mode. • Cleaning/replacing the carbon filter Unlike other carbon filters, the LONGLIFE carbon filter can be cleaned and reactivated. At normal use the filter should be cleaned every second month (when using the hood 2,5 hours per day, in avarage). The best way to clean the filter is in the dishwasher. Use normal detergent and choose the highest temperature (65. C). Wash the filter separately so that no food parts gets stuck on the filter and later causes bad odours. To reactivate the carbon, the filter should be dried in an oven for 10 minutes with a temperature of maximum 100. C. After approximately three years of use, the carbon filter should be replaced with a new one, as the odour reduction capacity will be reduced. • Fitting Remove the grease filters. Remove the frame i which supports the filter h by turning 90° the two knobs g. Insert the charcoal filter inside the frame and put all parts back in their place. Refit the grease filters. Fig. 4. • To remove proceed in the reverse order. • Always specify the hood model code number and serial numb...
Otros modelos de este manual:Los aficionados - DK 4360 (2.99 mb)
Los aficionados - DK 4390 (2.99 mb)
Los aficionados - DK 4360 (2.99 mb)
Los aficionados - DK 4360 (2.99 mb)