Votos - 3, Puntuación media: 4.3
(
)
)
|
Resumen del manual
Save the hardware. 2. Remove the cross bar and mounts from the fuel tanks. Save the hardware. 3. Remove the fuel supply hose from the bottom of the fuel tank and drain all remaining fuel into a suitable container. Awarning Gasoline is highly flammable and must be handled with care. Do not allow open flame, smoking or matches in the area. 4. Remove the fuel tank from the machine and save all of the hardware. Discard the fuel tank and the rubber grommets. 5. Cut the tie wraps that fasten the fuel supply hose to the frame rail. 6. Cut 10” (25,4cm) from the fuel supply hose and wire loom covering. Route on the inside of the frame rail. INSTALLATION 1. Install the iso mounts in the front inserts of the new tank. 2. Install the new tank mount bracket onto the existing tank mount plate and secure with the supplied hardware. See Figure 1 below for mount and hardware orientation. Make sure to use to holes to mount the bracket. 3. Install the fuel tank onto the machine and secure with all of the saved hardware. 4. Reconnect the fuel supply hose to the new fitting on the inside surface of the tank and secure with the saved hose clamp. Secure the fuel supply hose to the frame rail, making sure not to contact the pump cooling fan. 5. Reinstall the cross bar and mounts onto the new tank and secure with the saved hardware. 6. Reinstall the bumper and secure with the saved hardware. A. 3/8” x 1-1/4” Bolts E. B. 3/8” SAE Washers F. C. Tank Mount Bracket G. D. Tank Mount Plate H. 3/8” Fender Washers 3/8” Nylon Lock Nuts 5/16” x 1-1/4” Bolts 5/16” SAE Washers © Copyright 2003 Ferris Industries. All Rights Reserved. 1 48714 Rev. 03/2003 TP 200-7125-00-SK-D...
Otros modelos de este manual:Calentadores de Agua - Derby Colts & Stallions 45494KIT (33.14 kb)
Calentadores de Agua - Derby Colts & Stallions 45495KIT (33.14 kb)