Votos - 2, Puntuación media: 3.5
(
)
)
|
Resumen del manual
If this is not done, the adapter ground terminal is very likely to break with repeated use. Should the adapter ground terminal break, DO NOT USE the appliance until a proper ground has again been established. Use of Extension Cords Because of potential safety hazards under certain conditions, we strongly recommend against the use of an extension cord. However, if you still elect to use an extension cord, it is absolutely necessary that it be a UL listed 3-wire grounding type appliance extension cord having a grounding type plug and outlet and that the electrical rating of the cord be 15 amperes (minimum) and 120 volts. PRUDENCE Brancher la borne de terre d’un adaptateur sur la vis du couvercle de la prise murale ne met pas l’appareil a la terre, sauf si la vis du couvercle est metallique, n’est pas isolee et si la prise murale est mise a la terre par l’intermediaire des fils de la maison. Il faut faire verifier le circuit par un electricien qualifie pour s’assurer que la prise est correctement mise a la terre. Installation Preparation Beverage Center & Wine Chiller Reverse Door Swing To remove the door: • Remove the top hinge pin using a 1/8" Allen wrench. Set aside. • Lift the door off the bottom hinge. • Remove the top hinge and set aside. • Remove the bottom hinge, the plastic washer and the bottom hinge pin using a Phillips screwdriver. • Install the Phillips hinge pin in the top hinge and re-install the top hinge on the bottom left side. • Re-install the plastic washer over the hinge pin. • Install the Allen wrench hinge pin in the bottom hinge and re-install the bottom hinge on the top left side. • Insert the supplied plug buttons into the old hinge holes, top and bottom. The light trigger on the bottom of the door must be removed and secured to the opposite end. • Remove the light trigger by backing out 2 screws. Set the trigger and screws aside. • Install screws from plastic bag packed with Owner’s Manual into light trigger holes. • Turn the door upside down. • Measure and mark 12-1/4" and 13" from the right side (or 3/4" from the first location). Measure and mark 11/16" from the front side of the door. See illustration. • Drill holes with 5/32" drill bit. • Install the light trigger with original screws. • Remove the top hinge pin using the 1/8" allen wrench. • Place the door onto the bottom hinge, and install the top hinge pin with allen wrench. • Open and close door to test door swing. If door drags and does not close evenly, loosen hinge screws and slip shims behind the hinge. Tighten screws and test again. Position new nameplate: • Remove the original nameplate, now located on the bottom of the door. • Locate the template on the back of this instruction book. • Hold or tape template behind glass door. • Remove backing from Monogram nameplate. • Place nameplate onto front side of door, matching illustration on template. Top Hinge Bottom Hinge Light Trigger Top of the Door 12-1/4" Front of the Door 3/4"11/16" Slip Shim Behind Hinge Top of Name Plate Top of Glass Door Door Frame Side P/N 41005263 Upper LeftCorner ofGlass DOORNAME PLATELOCATION Installation Beverage Center & Wine Chiller Step 1 Remove the Packaging Step 2 Install Handle Remove all packing material and tape. B. C. Tools and materials required: • #2 Phillips screwdriver Parts List: D. A. Stainless tubular handle B. 2 Handle standoffs C. 3...
Otros modelos de este manual:Aire - ZDW24 WW (367.84 kb)
Aire - ZDW24 BB (367.84 kb)
Aire - ZDB24 BB (367.84 kb)