Votos - 4, Puntuación media: 4.3
(
)
)
|
Resumen del manual
Installing the appliance Transportation, unpacking It is recommended to deliver the appliance in original packaging, in vertical position considering the protective warning on packaging. After each transportation the appliance must not be switched on for approx. 2 hours. Unpack the appliance and check if there are damages on it. Report possible damages immediately to the place you bought it. In that case retain packaging. Cleaning Remove every adhesive tape and everything else, which ensure the accessories not to move in the appliance. Wash the inside of the appliance using lukewarm water and mild detergent. Use soft cloth. After cleaning wipe out the inside of the appliance. Placement The ambient temperature has an effect on the energy consumption and proper operation of the appliance. When placing, take into consideration that it is practical to operate the appliance between ambient temperature limits according to the climate class that is given in the chart below and can be found in the data label. Class of climate Ambient temperature SN +10…+32°C N +16…+32°C ST +18…+38°C If the ambient temperature goes below the lower data the temperature of the cooling compartment can go beyond the prescribed temperature. If the ambient temperature goes beyond the upper data this means longer operating time of the compressor, breakdown in the automatic defrosting increasing temperature in the cooling compartment or increasing energy consumption. In the bag of the accessories there are two spacers which must be fitted in the two top corners. Slacken the screws and insert the spacer under the screw head, the re-tighten the screws. When placing the appliance ensure that it stands level. This can be achieved by two adjustable feet at the bottom in front. Do not stand the appliance on a sunny place or close to a radiator or cooker. If it is unavoidable because of furnishing and the appliance has to be stood near a cooker take these minimum distances into consideration: In case of gas or electric cooker 3 cm must be left, when it is less put a 0,5-1 cm non-flam insulation between the two appliances. In case of oil or coal-fired stove the distance must be 30 cms since they give off more heat. The refrigerator is designed to operate when it is totally pushed to the wall. When placing the refrigerator keep minimal distances recommended in figure. A: placing it under a wall-cupboard B: placing it freely Change of door opening direction Should the setting-up place or handling demand it, door-opening direction can be refitted from right-handed to left-handed. Appliances on the market are right-handed. Following operations are to be done on the basis of figures and explanations: 1. To perform the operations listed below it is recommended to ask another person for help who safely can keep the doors while performing the operations. 2. Disconnect the appliance from the electricity supply. 3. Open the doors and dismount the double door hinge (a,b) by removing the screws (2 p...
Otros modelos de este manual:Refrigeradores - S 75348 KG (528.89 kb)
Refrigeradores - S 75348 KG (528.89 kb)
Refrigeradores - S 75348 KG (528.89 kb)
Refrigeradores - S 75388 KG (528.89 kb)