Votos - 4, Puntuación media: 4.3 ( )

Fabricar: AEG Tamaño del archivo: 528.89 kb Nombre del archivo: 371892EN.pdf Idioma del manual:

When placing the refrigerator keep minimal distances recommended in figure. A: placing it under a wall-cupboard B: placing it freely Change of door opening direction Should the setting-up place or handling demand it, door-opening direction can be refitted from right-handed to left-handed. Appliances on the market are right-handed. Following operations are to be done on the basis of figures and explanations: 1. To perform the operations listed below it is recommended to ask another person for help who safely can keep the doors while performing the operations. 2. Disconnect the appliance from the electricity supply. 3. Open the doors and dismount the double door hinge (a,b) by removing the screws (2 pieces) (c). (fig. 2) 4. Take off the double door hinge (a,b,c) by gradually removing it from the cabinet, slightly tilting both doors. Do not forget to remove the plastic spacer (b) under the hinge. (fig. 2) 5. Take off the refrigerator door by pulling it slightly downwards. 6. Take off the freezer door by pulling it slightly upwards. 7. Unscrew the top door hinge pin (d) of the refrigerator then screw it back on the other side. (fig. 1) 8. Remove the insert of the plinth (e) by a screwdriver. (fig. 4) 9. Unmount the lower hinge pin (f) and its washer (h) and mount them on the other side. (fig. 4) 10. Replace the insert of the plinth (e) on the other side. 11. Remove the covering nails (3 pieces) (n,k) of the double door holder on the left side and put them to the other side. (fig. 2) 12. Remove the (t, z) plugs from both doors. (fig. 3) 13. Remove the (u, v) door closing devices by unscrewing the (s) screw. 14. Unscrew the top handle bracket from the handle rod (1). Unscrew the bottom handle bracket from the door (2). Unscrew the top handle bracket from the door (3) and screw onto the bottom righthand side of the door (4). (fig.5) 15. Turn the handle bracket with the handle rod 180° and screw them to the door (5) and the fitted handle bracket (6). (fig.5) Do not overtighten the screw (max. 2 Nm) as you may damage the door handles. 16. Replace the (u, v) door devices on the opposite side of the other door after turning them, then fix them by screwing the (s) screw. 17. Replace the (t, z) plugs on the opposite side. 18. Fit the pin of the double door hinge (m) into the left drill of the freezer door. (fig. 2) 19. Fit the freezer door to the lower door hinge pin (f). (fig. 4) 20. Fit the refrigerator door to the upper door hinge pin (d) then slightly tilting both doors fit the pin of the double door hinge (m) into the left drill of the refrigerator door. 21. Opening both doors fix the double door hinge onto the left side using the screws (2 pieces) (c). Do not forget to replace the plastic spacer (b) under the hinge. Be careful that the door edges are parallel with the edge of the mantle. 22. Put the appliance to its place, set it level, and apply to voltage it. In case you do not want to perform the procedures above, call the nearest brand-mark service....

Descargar ahora

Introduzca dos números de la imagen: