Votos - 3, Puntuación media: 3 ( )

Fabricar: Amana Tamaño del archivo: 224.49 kb Nombre del archivo: Idioma del manual:

3. Take care of opening the freezer at a position of thermostatic control so that the inside temperature can never be warmer than -18 C. 4. It is practical to make sure of faultless operation of the appliance daily so as to notice possible failure in time and prevent deterioration of frozen foods. 5. Normal operating sounds: A thermostat controls the compressor and you will hear a faint click when thermostat cuts in and out. You may hear faint gurgling or bubbling sound when the refrigerant is pumped through the coils at the rear, to the cooling plate/evaporator. When the compressor is on, the refrigerant is being pumped round and you will hear a whirring sound or pulsating noise from the compressor. The fridge evaporator (this part cool down the fridge section) is foamed into the cabinet. The temperature of this part changing during its work, and parallel with this its dimensions are slightly changing, too. These changes might cause a cracking noise, which is a natural, harmless phenomenon. 6. Should you want to check the temperature of food stored in the refrigerator, place a glass of water centrally in the cabinet, and put a proper thermometer with an accuracy of +/- 1 °C into it. If after 6 hours you measure a value around that seen on the display, the refrigerator works properly. The measuring shall be performed under steady-stated conditions (without changing the load). 7. If the freezer temperature is measured using a thermometer, put it between the products since this will reflect the real temperature in the frozen products. It is normal that the built-in temperature display shows a temperature slightly above that measured in other ways. Hints and ideas In this chapter practical hints and ideas are given about how to use the appliance to reach maximum energy saving and there is environmental information about the appliance as well. How to save energy 1. Avoid putting the appliance in a sunny place or near anything that gives off heat. 2. Be sure that the condenser and the compressor are well ventillated. Do not cover the sections where ventilation is. 3. Wrap products in tightly closing dishes or cling film to avoid bulding up unnecessary frost. 4. Do not leave the door open longer than necessary and avoid unnecessary openings. 5. Put warm foods into the appliance only when they are at room temperature. 6. Keep the condenser clean. The appliance and environment This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. Information on your local disposal sites may be obtained from your municipal authorities. The materials used on this appliance marked with the sympol are recyclable. Maintenance Defrosting Defrosting is automatic in this model. Regular cleaning Clean the equipment regularly. Do not use deter...

Descargar ahora

Introduzca dos números de la imagen: