Votos - 1, Puntuación media: 5 ( )

Fabricar: Amana Tamaño del archivo: 224.49 kb Nombre del archivo: Idioma del manual:

Maintenance Defrosting Defrosting is automatic in this model. Regular cleaning Clean the equipment regularly. Do not use detergents, abrasive or strong odorous cleaners, waxy polishing agents or disinfectants or alcoholic products for cleaning the equipment. Before cleaning remove the plug from the mains supply. Internal cleaning Clean the internal parts of the equipment and the accessories with warm water and sodium bicarbonate (5 ml to 0.5 litre of water). Rinse and dry everything thoroughly. Clean the door seal profile with clean water. External cleaning Clean the external parts of the equipment with warm water and sodium bicarbonate (5 ml to 0.5 litre of water). It is recommended to remove the dust and dirt deposited on the back side of the equipment and on the condenser once or twice a year, and to clean the evaporation tray on top of the compressor. After cleaning, reconnect the equipment to the mains supply. Changing the Carbon Filter To maintain the best performance the carbon filter should be changed every year. New carbon filters can be purchased from your local dealer. 1. Pull the flap outwards. (1) 2. Remove the filter from the plastic bag. 3. Insert the filter in the slot found in the back of the flap cover (2). 4. Close the flap cover. Note: the carbon filter is a consumable accessory and as such is not covered by the guarantee. During operation, always keep the air ventilation flap closed. The filter should be handled carefully so fragments do not loosen from the surface. This appliance has a supplementary light at the bottom of the air distribution unit. Should this light not work, do not try to replace it yourself. Please, call the nearest Service Force Centre.. If something does not work During operation of the appliance some smaller but annoying trouble can often occur, which does not require calling a technician out. In the following chart information is given about them to avoid unnecessary charges on service. We draw your attention that operation of appliance goes with certain sounds (compressor- and circulating sound). This does not necessarily mean a fault has occurred, this goes together with the operation of the appliance. We draw it to your attention again that the appliance operates discontinuously, so the stopping of compressor does not mean being no-current. That is why you must not touch the electrical parts of the appliance before breaking the circuit. Problem Possible cause Solution It is too warm in the Thermostatic control can be set incor-Set the thermostat knob to higher refrigerator. rectly. position. If products are not cold enough or Place the products according to the placed incorrectly. chapter „Storing in the refrigerator”. The door does not close tightly or it is Check if the door closes well and the not shut properly. gasket is unhurt and clean. It is too warm in the Thermostatic control can be set incor-Set the thermostat knob to higher freezer. rectly. position. The door does not close tightly or it ...

Descargar ahora

Introduzca dos números de la imagen: