Votos - 4, Puntuación media: 3.5 ( )

Fabricar: Samsung Tamaño del archivo: 2.21 mb Nombre del archivo: Idioma del manual:

Cold Water line -Shut off the main water supply line and turn the Ice 2. Pipe Clamp.maker to the off position. 3.Copper (or Plastic) line -Locate the nearest cold drinking water line. 4.Compression Nut -Follow the instructions in the ice maker installation kit. 5.Compression Sleeve 6.Shut Off Valve 7.Packing Nut. Connect the water line to the refrigerator -Slip the compression nut and plastic ferrule through the plastic tube. -After inserting the sleeve, tighten the compres-sion nut onto 1/4” compression fitting(union). Do not overtighten the compression nut. NOTE -Slip the compression ferrule and nut on copper(or plastic) tubing as shown. Tighten the comperssion nut onto the com-pression fitting(union). -Turn water on and check for any leakege. NOTE Waterline must be connected to drinkable water only (Case 2) Nut Check the water supply line Connect the water pipe with coupler and tap. -Close the main water tap. -Connect coupler “A” to the tap. -Every join should be protected with sealing tape. Compression Ferrule Sleeve Compressionfitting Ferrule Compression Nut CAUTION The water line must be connect-ed to the cold water pipe. If it is connected to the hot water pipe, it may cause the purifier to malfunction. WARRANTY INFORMATION This water line installation is not covered by the refriger-ator or ice maker manufacturer's warranty. Follow these instructions carefully to minimise the risk of expensive water damage. COUPLER “A” Note: If the coupler does not fit on the current tap, go the nearest authorised service dealer and purchase the right couplers fittings. TAP 30 INSTALLING THE WATER DISPENSER LINE - Remove the compressor cover of the refrigerator. - Connect the water line to the valve, as shown in the figure. - When connected, check if there is any leakage. If any, repeat the connection. - Reattach the compressor cover of the refrigerator. WATER LINE CONNECTION NUT Connect the water line to the refrigerator. Secure the water line. COMPRESSOR COVER OF REFRIGERATOR -Using clip ”A”, fix the water line to the wall (the back of refrigerator). -When the water line is secure, make sure whether the water line is not excessively bent, pinched or squashed. CLIP A Complete the installation of the water supply line. -Power on the refrigerator and press the lever on the right of the dispenser until water runs out through the water line and all air has been empty. WATER LINE -At this time, check for any possible leakages at the join point in the water line. After securing the water line, move the refrigerator to the required location. Once the refrigerator is in position, do not move possibly. Install the water filter. -As shown, separate the sticker in the fefrigerator. Remove the water filter from the box and put a month indicator sticker on the filter as shown. -Write the month you installed the filter on the label. EX) If the water filter was installed in March, put “MAR” -Remove the protective cap then position and insert the filter as shown, -Slowly...

Descargar ahora

Introduzca dos números de la imagen: