|
Otros manuales para este modelo:
Resumen del manual
The tap must be near the appliance and also freely accessible following installation of the appliance. The enclosed hose set is 2 metres long. m Caution Use only the enclosed hose set or a hose set purchased from customer service for connection to the drinking water mains. Do not use existing or already used hose sets. Connect the appliance to a drinking water line only: ¦ Minimum pressure: 0.2 Mpa (2 bar) ¦ Maximum pressure: 0.8 Mpa (8 bar) ¦ Pressure over 0.8 MPa (8 bar): install a pressure limiter between drinking water connection and hose set m Caution Do not kink, crush, modify or cut through the water supply hose! Fig. . Note The maximum outside diameter of the water mains (without connecting pieces) is 25 mm. m Caution After dispensing for the first time, check that the connections are tight! Fig. 2 Electrical connection The socket must be near the appliance and also freely accessible following installation of the appliance. The appliance complies with the protection class I. Connect the appliance to 220–240 V/50 Hz alternating current via a correctly installed socket with protective conductor. The socket must be fused with a 10 to 16 A fuse. For appliances operated in non- European countries, check whether the stated voltage and current type match the values of your mains supply. This information can be found on the rating plate. Fig. 3 m Warning Never connect the appliance to electronic energy saver plugs. Our appliances can be used with mains and sine-controlled inverters. Mains- controlled inverters are used for photovoltaic systems which are connected directly to the national grid. Sine-controlled inverters must be used for isolated applications (e.g. on ships or in mountain lodges) which are not connected directly to the national grid. en Getting to know your appliance Please fold out the illustrated last page. These operating instructions refer to several models. The features of the models may vary. The diagrams may differ. Fig. ! * Not all models. 1-5 Controls 6 Light (LED) 7 Glass shelf 8 Condensation outlet 9 Vegetable container 10 Height-adjustable feet 11 Butter and cheese compartment 12 Egg rack* 13 Door shelf “EasyLift” 14 Shelf for large bottles 15 Water dispenser Controls Fig. " 1 On/Off button Serves to switch the appliance on and off. 2 “super” button Is used to switch on the super cooling (see chapter entitled “Super cooling”). 3 Temperature selection button Press this button to set the temperature. 4 Temperature display The numbers correspond to the set refrigerator compartment temperatures in °C. 5 Alarm button Used to switch off the warning signal, see chapter “Alarm function”. en Switching the appliance on Fig. " Switch on the appliance with the On/Off button 1. The temperature display 4 indicates the selected temperature. The appliance starts to cool, the light is switched on when the door is open. When the appliance has been switched on, it may take several hours until the set temperature has been reached. Do not put any food in the appliance beforehand. Operating tips ¦ While the refrigeration unit is running, water droplets or a thin layer of ice may form at the rear panel of the refrigerator. This is nothing unusual. It is not necessary to scrape off the frost or wipe off the water droplets. The rear panel defrosts automatically. The condensation collects in the condensation channel and is carried to the refrigeration unit where it evaporates. ¦ If the air humidity is high, condensation may form in the refrigerator compartment, especially on the glass shelves. If this is the case, pack or wrap the food and select a lower temperature in the refrigerator compartment. Setting the temperature Refrigerator compartment Fig. " Keep pressing temperature setting button 3 until the required refrigerator compartment temperature is set. The value last selected is saved. The set temperature is indicated on temperature display 4. We recommend a factory setting of +4 °C in the refrigerator compartment. Perishable food should not be stored above +4 °C. Alarm function Door alarm The door alarm (continuous sound) switches on if the appliance door is open for longer than two minutes. Close the door to switch off the warning signal. Switching off the alarm Fig. " Press the alarm button 5 to switch off the warning signal. AquaStop Alarm The integrated AquaStop system switches on when water comes out of the mains pipe. The water supply is automatically interrupted. The “lock” and “on/off” buttons flash. The cooling function of the appliance is not affected. Switch off the water supply and inform customer service. en Usable capacity Information on the usable capacity can be found inside your appliance on the rating plate. Fig. 3 Refrigerator compartment The refrigerator compartment is the ideal storage location for meat, sausage, fish, dairy products, eggs, ready meals and pastries. Storing food ¦ Store fresh, undamaged food. The quality and freshness will then be retained for longer. ¦ In the c...
Otros modelos de este manual:Refrigeradores - KSW36PW30/01 (1.69 mb)