If the refrigerator changes ownership, be sure this manual accompanies refrigerator. Consumer Information Line 1-800-843-0304 Contents Electrical Requirements_ Model Identification_ Setting Controls Temp-Assure™ _ Refrigerator and Freezer Model Diagrams_ Refrigerator Features Refrigerator Shelves Deli Chiller.- Crisper Drawers _ Utility Rack (some models) Egg Bucket 2 3 4 4 6 8 8 10 12 12 12 Snaccess Bin (some models) _ Dairy Module and Food Storage Container System (some m

This appliance is designed for domestic use only. Specialised companies that are qualified to do so by the manufacturer must carry out service and repairs including repairing and changing the power cord. Accessory parts supplied by them should be used only for repairing. Otherwise the appliance can be damaged or can cause other damage or injury. The appliance is out of circuit only in that case if the plug is removed from the socket. Before cleaning and maintenance always unplug it (do not get i

– 89/336/EWG dated 3 May 1989 (including guideline change notice 92/31/EWG) Fix cover (C) on guide (A) until it clips into place. Open the appliance door and the furniture door at 90°. Insert the small square (B) into guide (A). Put together the appliance door and the furniture door and mark the holes as indicated in the figure. Remove the squares and drill holes with o 2 mm at 8 mm from the outer edge of the door. Place the small square on the guide again and fix it with the screws supplied. Sh

If the floor is not level it is necessary to shim the rear wheels onto a piece of plywood or other shim material so refrigerator is level. A WARNING To avoid electrical shock which can cause severe personal injury or death, disconnect power outlet from main power supply before installing or servicing refrigerator. Prepare refrigerator for delivery Some installations may require door removal to get the refrigerator into the home. 1. Remove toe grille. 2. Remove top hinge cover and top hin

Turn the thermostat knob to a warmer setting temporarily. Interior lighting does not work. Light bulb is defective. Please look in the “Changing the Light Bulb” section. Symptom Possible Cause Remedy Temperature is not properly adjusted. Please look in the “Initial Start Up” section. Door was open for an extended period. Do not leave the door open any longer than necessary. The food is too warm. A large quantity of warm food was placed in the appliance within the last 24 hours. Turn the thermost

The filter should be placed behind the grill before the cabinet is turned on. 0 1. The cover can be opened by simultaneously pressing the lever on the right of grill (1) and pulling the cover outward (2). 2. The carbon filter is then mounted in the slot found in the back of the cover (3). 1 The filter should be handled carefully so fragments don.t loosen from the surface. Installation Electrical Connection Any electrical work required to install this appliance should be carried out by a qualifie

It is recommended that a separate circuit serving only your refrigerator be provided. Use an outlet that cannot be turned off by a switch. Do not use an extension cord. Water: A cold water supply with water pressure between 30 and 120 psi (207 and 827 kPa) is required to operate the ice maker. If you have questions about your water pressure, call a licensed, qualified plumber. If a reverse osmosis water filtration system is connected to your cold water supply, the water pressure to the system

It is recommended that a separate circuit serving only your refrigerator be provided. Use an outlet that cannot be turned off by a switch. Do not use an extension cord. Water: A cold water supply with water pressure between 30 and 120 psi (207 and 827 kPa) is required to operate ice maker and water dispenser. If you have questions about your water pressure, call a licensed, qualified plumber. IMPORTANT: The pressure of the water coming out of a reverse osmosis system going to the water inlet v