Iniciar sesión:
Votos - 4, Puntuación media: 3.5 ( )

Manual de usuario Brunton, modelo SolarFlat 2W/12V

Fabricar: Brunton
Tamaño del archivo: 724.62 kb
Nombre del archivo:
Idioma del manual:en
Enlace gratuito para este manual disponible en la parte inferior de la página



Resumen del manual


All 12V batteries like ones used in cars, Controller Charger? 2. What type of batteries can my SolarFlat 2 charge? A. All 12V batteries like ones used in cars, boats, RV’s, motorcycles and PWC’s. including UV protection and for weather effects of -35° F to 175 ° F. 2. Will panel drain battery at night? boats, RV’s, motorcycles and PWC’s. 2. Can I overcharge my battery? A. Yes! It is recommended to use our 7 Amp A. You can connect up to 105 watts of solar power. Panels should be connected in parallel – positive to positive and negative to negative. 3. Can I overcharge my battery? A. The SolarFlat 2 has a built in blocking diode that prevents battery discharge and A. No, this panel includes a battery diode to prevent battery drain and reverse current. 3. What type of batteries can my SolarFlat 5 charge? Solar Controller to not overcharge the battery 3. Will the SolarFlat15 keep my battery fully charged? 2. When will the Charging Indication light (green) light up? A. The charging controller indication green overcharging. A. Any deep cycle 12V battery. A. Yes, using the power of the sun, the light will light up when the battery voltage 4. Will the SolarFlat 2 keep my battery fully charged? A. The Maintainer charges your battery with the 4. How long will it take to charge a battery? A. Under ideal conditions, this panel will SolarFlat 15 will keep a battery charged. 4. How long does it take to charge a dead battery? reaches 14.2 Volts and the SCC will prevent the solar panels from overcharging the battery. It is normal for the SCC LED to power of the sun. It compensates for key generate up to 300 mAmps of current. A 5W A. Under ideal conditions, this panel will light on and off as the battery voltage cuts in offdrain and long periods of non-use and on panel is not designed to charge batteries, but generate up to 900 mAmps of current. A 40 and out. board electronics. It is designed to maintain only trickle charge batteries thereby insuring Amp Hr. battery at 50% would take 20 Hrs. batteries. quick starts. By doubling the amount of panels, you would 5. How long does it take to charge a dead battery? 5. Can I run appliances off this panel? reduce the time by half. A. The unit is designed to maintain batteries A. Yes, however, the current will vary depending 5. Can I extend the wire? only. If the battery is dead, we recommend a on the sunlight. Charging a battery is A. The 12ft wires can be extended up to a larger output solar charger such as the 5W or therefore the recommended installation and maximum of 30ft. with 16 gauge wire. 15W Brunton SolarFlats. running protocol 6. How many batteries can I using 1 unit? 6. Can I extend the wire? 6. Do I need a Solar Controller? A. The SolarFlat 15 is capable of charging a A. The 12’ wire can be extended up to 25’ A. No, a charge controller is only recommended bank of batteries, but the charge will be without loss of power of voltage damage. for panels greater than 15W. 7. How far can I extend the wire? A. Current length should accommodate 95% of installations, however, wires can be extended up to a maximum of 30ft. with 16 gauge wire. divided. 7. Can this solar charger run my house? A. No, the panel is best used to charge 12V batteries 8. Is the my solar charger weatherproof? A. Yes, this panel is fully weatherproof. Brunton Solar Panel Instructions SolarFlat 2W/6V Battery “Maintainer” SolarFlat 5W/24V Battery “Trickle Charger” Connecting Multiple Panels • Using the included bare wire connector adaptor, join positive wires to positive wires and negative wires to negative wires to ensure voltage. Make sure all connections are tight using wire nut connectors. Insulating materials may prove helpful. • For anything above 15W, use a Solar Controller Charger to prevent battery overcharge. General Solar Information A. How do solar cells generate electricity? Solar panels, also known as Photovoltaics, or PV for short, can be thought of as a direct current (DC) generator powered by the sun. When light photons of sufficient energy strike a solar cell, they knock electrons free in the structure forcing them through an external circuit (Battery or direct DC load), and then returning them to the other side of the solar cell to start the process all over again. B. Will solar work in my location? Yes, solar is universal and will work virtually anywhere, however, some locations are better than others. Irradiance is a measure of the sun’s power available at the surface of the earth, and it averages about 1000 Watts per square meter. Obviously, different parts of the world receive more sunlight than others, so they will have more “full sun hours” per day, resulting in more power from solar panels. C. These panels are made of amorphous type solar panels. What is the difference between amorphous and polycrystalline cells? Amorphous solar panels contain no cells per say, but are created through a deposition process which actually forms the silicon material directly on the glass substrate. To un...

Otros modelos de este manual:
cargadores - SolarFlat 15W/12V (724.62 kb)
cargadores - SolarFlat 5W/12V (724.62 kb)

Comentarios



Tu reseña
Tu nombre:
Introduzca dos números de la imagen:
capcha





Categoría