Votos - 0, Puntuación media: 4 ( )

Fabricar: Black & Decker Tamaño del archivo: 2.36 mb Nombre del archivo: Idioma del manual:

A built-in mechanical interlock prevents changing the direc-. tion of the tool with the Slide Switch unless the Trigger Switch is released, turning the tool “OFF” during the directional change. After any reversing, return switch to forward position. 4 SWITCHES (Continued) switch locking button and %" drills -have a switch locking button. This button permits locking the trigger in the full “ON” position for continuous operation. To lock trigger in “ON” position depress trigger and push in locking pin (located next to trigger). To release locking mechanism, depress and release trigger. For maximum tool life avoid excessive reverse operation. For those operations where the tool is used primarily in reverse, see your Black and Decker Distributor or Black and Decker Service Center. CLEANING With the tool motor running, blow dirt and dust out of all air vents with dry air at least once a week, ' LUBRICATION Your tool was properly lubricated before leaving the factory. In from two to six months, depending upon use, take or send your tool to-a Black & Decker Service Center, or Authorized Service Station, for a complete cleaning, inspection and relubrication. Tools used .constantly on production or heavy duly jobs or exposed to heat may require more frequent lubrication. Tools “out of service" for long periods should be relubricated' before being put back into .service. ATTACHING SIDE HANDLE Drop the hexagon head bolt into the handle. Several threads will protrude thru the handle. Engage these threads into the threaded hole in the tool and turn clockwise until tight (Fig. 2). During tightening, the hexagonal head of the bolt is seated into a socket within the handle. The Handle/Bolt when assembled properly will remain intact when moving the side handle to the opposite side of the tool. 5 OPERATION CAUTION: Always unplug the tool when attaching or changing bits or accessories, 1. Open chuck jaws by turning collar with fingers and insert shank of bit about' %” into chuck. Tighten chuck collar by hand. Place chuck key in each of the three.holes, and tighten in clockwise direction, It's important to tighten chuck with all three holes. To release bit, turn chuck key counter clockwise in just ’ one hole, then loosen chuck by hand, 2, -Use sharp-drill bits only, For WOOD, use twist drill bits,, spade bits, power’ auger 'bits, or hole saws. For METAL, use high-speed steel twist drill bits or hole saws. For MASONRY, such as brick, cement, cinder block, etc., use carbide-tipped bits, 3. Be sure the material to be drilled is* anchored or ¿lamped firmly. If drilling thin material, use a wood “back-up" block to prevent damage to the material. 4, Always apply pressure in a straight line with the bit. Use enough pressure to keep drill biting, but do not push hard enough to stall the motor or deflect the bit ' 5. Hold drill firmly to control the twisting action of the drill. Use side handle. 6. IF DRILL STALLS, it is usually because it is being over...

Descargar ahora

Introduzca dos números de la imagen: