Votos - 3, Puntuación media: 4
(
)
)
|
Resumen del manual
Brushes should be regularly inspected for wear if your tool has extfrior brush inspection caps. When the cap is unscrewed, the spring and brush assembly may be withdrawn from the tool, Keep brushes clean and sliding freely in their guides. Inspection should be made every two to six months, depending upon usage, SWITCHES. Pulling the Trigger Switch turns the tool “ON”; releasing the trigger, turns the tool “OFF”, y2" drills have reversing capability. For controlling the rotational direction of the spindle, there is a slide switch built into the handle. For drilling, this switch is put in the down, “F” (forward) position. For easing drill bits out of tight holes, move the slide switch up to the “R” (reverse) position. The switch provided is a common part with other tools, ignore “Hi/Lo” marking for this tool. A built-in mechanical interlock prevents changing the direc-. tion of the tool with the Slide Switch unless the Trigger Switch is released, turning the tool “OFF” during the directional change. After any reversing, return switch to forward position. 4 SWITCHES (Continued) switch locking button and %" drills -have a switch locking button. This button permits locking the trigger in the full “ON” position for continuous operation. To lock trigger in “ON” position depress trigger and push in locking pin (located next to trigger). To release locking mechanism, depress and release trigger. For maximum tool life avoid excessive reverse operation. For those operations where the tool is used primarily in reverse, see your Black and Decker Distributor or Black and Decker Service Center. CLEANING With the tool motor running, blow dirt and dust out of all air vents with dry air at least once a week, ' LUBRICATION Your tool was properly lubricated before leaving the factory. In from two to six months, depending upon use, take or send your tool to-a Black & Decker Service Center, or Authorized Service Station, for a complete cleaning, inspection and relubrication. Tools used .constantly on production or heavy duly jobs or exposed to heat may require more frequent lubrication. Tools “out of service" for long periods should be relubricated' before being put back into .service. ATTACHING SIDE HANDLE Drop the hexagon head bolt into the handle. Several threads will protrude thru the handle. Engage these threads into the threaded hole in the tool and turn clockwise until tight (Fig. 2). During tightening, the hexagonal head of the bolt is seated into a socket within the handle. The Handle/Bolt when assembled properly will remain intact when moving the side handle to the opposite side of the tool. 5 OPERATION CAUTION: Always unplug the tool when attaching or changing bits or accessories, 1. Open chuck jaws by turning collar with fingers and insert shank of bit about' %” into chuck. Tighten chuck collar by hand. Place chuck key in each of the three.holes, and tighten in clockwise direction, It's important to tighten chuck with all three holes. T...
Otros modelos de este manual:Taladros y shuropopverty - 1070-21 (2.36 mb)
Taladros y shuropopverty - 1190-09 (2.36 mb)
Taladros y shuropopverty - 1190-21 (2.36 mb)
Taladros y shuropopverty - 1335-09 (2.36 mb)