Votos - 3, Puntuación media: 3.7
(
)
)
|
Resumen del manual
The C1553/C1554 (also sold as C1552) combination produces the classic Ogee finish. Fitted with precision guide bearings, these bits are capable These router bits have sharp edges. use care while removing the waxy protec- tive coating. Never turn on the router with the protective coating still on the bit. •Failure to follow theSE guidelines will result in seri- ous personal injury. •ALWAYS WEAR ANSI APPROVED EYE AND EAR PROTECTION WHEN USING THIS BIT. •The use of a router table is strongly recommended. •Never feed lumber with the rotation of the bit. •Follow the safety guidelines set forth by the manufactur- er of the router and router table. C1550/C1553 C1551/C1554 of being used with a hand held or table mounted router. Using a table mounted router will give best results. For maximum operating efficiency, a router rated at 1 horsepower or larger is recommended. The maximum frame thickness: 13.8". Note: These instructions and drawings are intended for explanation and clarification purposes only as they relate to this particular router bit. Apply all safety rules and measures pertaining to router operations and your specific operation. Refer to the owner’s manual supplied with your router and router table for specific warnings and instructions before proceeding with equipment operations. Step 1: Cutting Stile and Rail Edges Make sure the router is disconnected from the Top of Bead • Unplug router before power source. Install the stile and rail cutter. Outer Side installing or adjusting (C1551 or C1554.) Attach the router to your router table and adjust the height of the bit until the top of the bead is 1.16" below the top bit. • Keep all guards and anti- of your stile. See Figure A. Adjust the fence kickback devices in place. until it is flush with the bearing. (The bearing • Double check bit to insure can be used without the fence when you are nut is tight and bit is tight cutting non-linear shapes such as a curved and secure in spindle. arch door rail, however a starting pin should • Always inspect lumber and Router Table be employed to help make safe first contact to other wood materials for workpiece). The workpiece must always be fed Figure A cracks, knots, or other against the cutter rotation and the full depth of pro- imperfections that could file should be made in one pass to ensure a precise cut. If the window is not to be cause bit or lumber to kick painted, a side should be chosen for appearance and marked with a pencil. Before or shatter while milling. plugging in the router, set a piece of scrap, the same size as the workpiece, on the table appearance side up. Lay the edge to be cut firmly against the fence. A hold- down device such as a featherboard should be used to keep the workpiece secured against the fence. Make a test cut to ensure that the complete profile is being cut. Adjust, if necessary, and re-test. Run all of the stiles and rails for the project through the cutter before changing bits to do the rail ends. 529003622 © May ...
Otros modelos de este manual:Puertas y ventanas - 1553 (155.38 kb)
Puertas y ventanas - 1554 (155.38 kb)
Puertas y ventanas - C1550 (155.38 kb)
Puertas y ventanas - C1552 (155.38 kb)