Votos - 2, Puntuación media: 4.5 ( )

Fabricar: Finlandia Tamaño del archivo: 841.43 kb Nombre del archivo: Idioma del manual:

Example 2. If you want to bathe .immediately” and thus do not want to use the pre-set timing, the timer must be set to the desired point in the section 0.1. Then, the heater will be switched immediately on and the sauna will be ready for bathing after about one hour. Switch the heater off immediately after bathing and check that the sauna rocks are dry. Sometimes it may be advisable to leave the heater on for a while to let the wooden parts of the sauna dry properly. NOTE! It is absolutely necessary to check that the timer has cut off the supply of the elements after the set time. 1.3.2. Thermostat The temperature is adjusted by the thermostat to a position between minimum and maximum. See figure 2. The correct position of the thermostat switch is found by experimenting. Begin experimenting at the maximum position (far right) to find how quickly the sauna room and rocks can be heated to the desired temperature. If, during bathing, the temperature seems to be becoming too high, turn it down a little by turning the switch counter-clockwise. It must be noted that even a small difference within the maximum section will change the temperature of the sauna considerably. 1.3.3. Overheating limiter Each heater i equipped with a overheating limiter which is a safety device. If, for some reason, the temperature of the sauna room becomes too high, the overheating limiter will permanently cut off the supply of the resistances. The overheating limiter cannot be reset to the position allowing electricity until the heater has cooled down. The overheating limiter is reset by pressing the reset button, which is located in bottom of heater. See figure 3. To reset the overheating limiter, locate the reset button and push upward until contactor kicks in. If reset button continues to trip, contact a qualified service person. Do not remove the overheating limiter bulb. See spare parts no. 2. Prior to pressing the button, the cause of the fault must be found: • are the rocks crumbled and pressed together? • has the heater been on for a long time while unused? • has the heater been banged or shaken? 1.4. Throwing Water on Heated Stones The air in the sauna room becomes dry when warmed up. Therefore, it is necessary to throw water on the heated rocks to reach a suitable level of humidity in the sauna. The humidity of the air in the sauna room is controlled by the amount of water thrown on the rocks. A correct level of humidity makes the bather.s skin sweat and makes breathing easy. By throwing water on the rocks with a small ladle, the bather should feel the effect of air humidity on his skin. Both too high a temperature and air humidity will give an unpleasant feeling. Staying in the hot sauna for long periods of time makes the body temperature rise, which may be dangerous. The maximum volume of the ladle is 2 decilitre...

Descargar ahora

Introduzca dos números de la imagen: