Iniciar sesión:
Votos - 2, Puntuación media: 3 ( )

Manual de usuario Desa, modelo ELECTRIC SAUNA HEATER JM-30

Fabricar: Desa
Tamaño del archivo: 841.43 kb
Nombre del archivo:
Idioma del manual:
Enlace gratuito para este manual disponible en la parte inferior de la página



Resumen del manual


• the moisture protection consists of e.g. aluminium paper with tightly taped edges. The paper must be fitted so that the glossy side is towards the inside of the sauna. • there is a 3/8" (10 mm) vent gap between the moisture protection and panel boards (recommendation). • the inside is covered by 1/2" – 5/8" (12.16 mm) thick panelling. • there is a vent gap of a few millimetres at the top of the wall covering at the edge of the ceiling panelling. When aiming at a reasonable heater output, it may be advisable to lower the ceiling of the sauna (normally 6’.10 11/16" (2100 mm), minimum height 59 1/16" (1500 mm). As a result, the volume of the sauna is decreased, and a smaller heater output may be sufficient. The ceiling can be lowered so that the ceiling joists are fixed at a suitable height. The spaces between the joists are insulated (minimum insulation 4" (100 mm) and surfaced as described above. Because heat goes upwards, a maximum distance of 38" (970 mm) is recommended between the bench and ceiling. NOTE! Consult fire-extinguishing authorities to find out which part of the fireproof wall may be insulated. NOTE! The protection of the walls or ceiling with heat protection, such as mineral board fitted directly on the wall or ceiling, may cause the temperature of the wall and ceiling materials to rise dangerously high. 2.1.1. Room construction – general information FRAMING 2" x 4" Dry Douglas Fir, 16" o.c. CEILING HEIGHT No higher than 7' 0". INSULATION R11 Fiberglas with foil back in walls and ceiling, foil facing into room. DRYWALL See local codes. Is not required in most residences. See local codes for commercial. If drywall is used, apply 1" x 2" nailers so that wall and ceiling boards can be attached to solid wood. PANELING Use kiln-dried, clear,T&G softwood such as California Redwood, Western Red Cedar, Alaska yellow Cedar, with moisture content not exceeding 11%. Figure4.Saunaroom BENCHES HEATER GUARDRAIL DOOR ROOM LIGHT Use matching wood of vertical grain with 2"x 2" tops – 1/2" spacing -and 2"x 4" facing, fastening from bottom to prevent burning of bathers. Use matching softwood of 1"x2"or2"x2". Must open out and should not have a lock. Size – 2' 0"x 6’8" with fir rails and double sealed, tempered glass. Should be a vapor proof, wall- mounted type, with rough-in box mounted flush with inside paneling. It should mount 6" (150 mm) from ceiling, not directly over the Sauna heater, and not over upper benches; light bulb should not exceed 75 watts. Note! Receptacles OR PLUGS are not allowed in a Sauna room. If a speaker is installed in a Sauna room, it should not be installed higher than 3' from floor, away from the Sauna heater (consult manufacturer for ratings). 2.2. Sauna Room Floor Due to a large variation in temperature, the sauna rocks disintegrate in use. Small pieces of rock are washed down on the sauna room floor along with the water thrown on the rocks...

Otros modelos de este manual:
Eléctrico - ELECTRIC SAUNA HEATER JM-20 (841.43 kb)
Eléctrico - ELECTRIC SAUNA HEATER JM-17 (841.43 kb)
Eléctrico - ELECTRIC SAUNA HEATER JM-17 (841.43 kb)
Eléctrico - ELECTRIC SAUNA HEATER JM-17 (841.43 kb)

Comentarios



Tu reseña
Tu nombre:
Introduzca dos números de la imagen:
capcha





Categoría