Votos - 1, Puntuación media: 3 ( )

Fabricar: Globe Tamaño del archivo: 323.56 kb Nombre del archivo: Idioma del manual:

NOTE: The SP62P and SP80PL will automatically shut off if the speed is changed while the mixer is in operation. NOTE: The mixer is equipped with a motor overload protection. If the mixer shuts off during operation reduce the batch size and a. SP25 and smaller models: Press the stop button then press the overload reset button. b. Larger models: Wait two minutes. Press the stop button then press the start button. NOTE: 2nd speed should never be used on 50% AR or lower with the exception of the SP60P. The SP60P requires a 50% reduction in batch size to mix in speed 2 with 50% AR doughs. NOTE: Reduce batch size by 10% if chilled flour, water below 70°F, ice, or high gluten flour is being used. IMPORTANT: For heavier loads, the mixer should not run longer than fifteen minutes without pausing for a cool down period of at least fifteen minutes or more before resuming mixing. For lighter loads the mixer should not run longer than thirty minutes without pausing for a cool down period of at least thirty minutes or more before resuming mixing. 8. When the ingredients have been thoroughly mixed, press the red stop button to stop the mixer. NOTE: If the timer was used the mixer will automatically stop when the time has expired. 9. Lower the bowl by pulling the bowl lift lever forward and down to its resting position. For models SP40P and SP60P, rotate the bowl lift wheel counterclockwise until it stops. For models SP62P and SP80PL press the down arrow (blue button) until the bowl stops. 10. Rotate the bowl guard to the left so it is in the open position. 11. Remove the agitator from the planetary shaft by lifting it upwards then rotating it counterclockwise until it is unlocked. Lower the agitator and remove from planetary shaft. Page 9 Operating Instructions 12. Push each bowl clamp backwards to unlock the bowl from the bowl cradle. 13. Lift up slightly on the bowl so it clears the pins on the bowl cradle. Most batches are heavy. Always use two people to remove and transport the loaded bowl after mixing is complete. A bowl truck is included with the SP60P, SP62P, and SP80PL models and should be used to unload bowls containing more than 50 lbs. per batch. HOW TO USE THE ATTACHMENT HUB Never put your hand into the feed chute when using any mixer attachment. The mixer must be OFF before installing attachments! Do NOT use attachments while mixing! Thumbscrew 1. Loosen and remove the attachment hub thumbscrew. Plastic Cover 2. Remove the plastic cover from the attachment hub. 3. Lubricate the attachment shaft with a food quality grease or mineral oil. 4. Insert the attachment shaft into the hub making sure to line up the alignment pin with the hub hole. 5. Tighten the thumbscrew back into the hub and securely tighten it. 6. Select the appropriate speed setting by lifting or lowering the speed control lever. Recommended Speed while using attachments: Attachment Recommended Speed Vegetable Slicer 1 or 2 Cheese Shredder/Grater 2 or 3 Meat Grinder 1 only NOTE: Make sure the bowl is up and the bowl guard is closed. The mixer will not start if the bowl and the bowl guard are not in the proper operating position. 7. Turn the timer knob in a counterclockwise direction to the green “on” position. 8. Press the green start button located on the middle of the control panel. Always STOP the mixer BEFORE changing speeds! Failure to do so may damage the gears or other parts and WILL void the warranty! 9. To change the spe...

Descargar ahora

Introduzca dos números de la imagen: