Votos - 3, Puntuación media: 4
(
)
)
|
Resumen del manual
• Clearance for operating controls, installing and removing agitators, bowl, or attachments. • Sufficient space for adding ingredients during mixing periods. • Ensure rear ventilation outlet of mixer is not blocked. 5. Use at least two other people to tilt the unit and install the rubber feet. 6. A bolt down template and bolts are available for the SP10, SP20, or SP25. Contact Globe if this is needed. 7. Inspect the mixer to ensure all parts have been provided (i.e. bowl, beater, whip, and dough hook). The SP62P only has a bowl and dough hook. 8. Read the electrical information found on the data plate located at the rear of the machine. The incoming power should match the rating on the data plate. CONNECTING TO ELECTRICAL POWER Cord Connected Units: This machine is provided with a three-prong grounding plug. The outlet that this plug is connected to must be properly grounded. If the receptacle is not the proper grounding type contact an electrician. Do not under any circumstances cut or remove the third ground prong from the power cord or use any adapter plug. Never use an extension cord. Low amp supply could damage the mixer or cause a fire. Page 6 Installation CONNECTING TO ELECTRICAL POWER cont’d. Units Without Power Cord or Plug: Have a licensed electrician connect the unit to the power supply. Three Phase Units: Have a licensed electrician wire the machine correctly to ensure that the planetary is rotating in the same direction as the arrow sticker located on the front of the machine. Check the rotation of the planetary shaft prior to first use. When standing in front of the mixer, the planetary shaft should be moving in a clockwise direction (i.e., the planetary shaft should appear to move from right to left). If the unit is operated backwards (counterclockwise) damage will occur to the mixer! 9. Complete the warranty card and mail it to Globe or register online at 10. Clean the mixer prior to using it. Follow the cleaning instructions on page 11. NOTE: It is normal for the factory to apply a generous amount of grease in and on the machines before initial use. Excess grease (brown in color) will be on all metal surfaces (e.g. top portion of bowl guard, speed control, bowl clamps, bowl lift lever, and attachment hub thumbscrew). Excess high-pressured grease (brownish-black) may also be found on the planetary shaft and some drippings may be found in the bowl. Operating Instructions TO AVOID SERIOUS PERSONAL INJURY: • DO NOT remove the bowl guard. • DO NOT operate the mixer before reading the instruction manual first. • ALWAYS disconnect or unplug electrical power before cleaning, servicing, or adjusting any parts or attachments. • ALWAYS keep hands, hair, and clothing away from moving parts. ATTACHING THE BOWL TO THE MIXER NOTE: Install the bowl BEFORE attaching the agitators. 1. Lower the bowl by pulling the bowl lift lever forward and down to its resting position. For models SP40P and SP60P rotate the bowl lift wheel counterclockwise until it stops. For the SP62P and SP80PL press the down arrow (blue button) to lower the bowl until it stops. Fig. 7-1 2. Lift the bowl by the bowl handles and a. slowly position the locking pin (located on the rear of the bowl) into the hole in the middle rear of the cradle (see fi g 7-1). b. lower the bowl onto the pins located on either side of the bowl cradle. 3. Once the bowl is positioned on the cradle, secure the ...
Otros modelos de este manual:Mezcladoras - SP20 (323.56 kb)
Mezcladoras - SP10 (323.56 kb)
Mezcladoras - SP30 (323.56 kb)
Mezcladoras - SP30P (323.56 kb)