Votos - 3, Puntuación media: 4.7 ( )

Fabricar: Network Computing Devices Tamaño del archivo: 194.68 kb Nombre del archivo: Idioma del manual:

Install the other end of the air line tubing into the push-to-connect fitting on the air spring see Figure "A". Insert the tubing as far as possible into the fitting. Route the tubing to avoid sharp edges and direct heat from the exhaust system. Secure the tubing to the vehicle with the nylon ties provided. STEP 4 - INSTALL THE MANUAL INFLATION VALVE Cut the air line tubing in a convenient location between the gauge panel and the air tank. Install a push-to-connect T-fitting between the gauge panel and the air tank see Figure "A". Select a location on the vehicle for the manual inflation valve. This location can be anywhere on the chassis of the vehicle, as long as it is in a protected location so the valve will not be damaged, but maintain accessibility for the air chuck. Drill a 5/16" hole and install the air inflation valve using two 5/16" flat washers per valve see Figure "F". Route the air line tubing from the T-fitting to the inflation valve. Avoid direct heat from the exhaust pipe FUSE HOLDER kit. "A". Figure "I" AIR LINE PUSH-TO-CONNECT INFLATION VALVE FLAT WASHER HEX NUT VALVE CAP BODY OF VEHICLE GROUND WIRE TERMINALCONNECTOR BACK OFGAUGE RINGCONNECTOR TERMINALCONNECTORPOSITIVE WIRE EXISTINGWIRECONNECTING WIRE PLASTIC CONNECTOR FUSE HOLDER kit. "A". Figure "I" AIR LINE PUSH-TO-CONNECT INFLATION VALVE FLAT WASHER HEX NUT VALVE CAP BODY OF VEHICLE GROUND WIRE TERMINALCONNECTOR BACK OFGAUGE RINGCONNECTOR TERMINALCONNECTORPOSITIVE WIRE EXISTINGWIRECONNECTING WIRE PLASTIC CONNECTOR and away from sharp edges. Secure the tubing with the provided nylon ties. Push the end of the air line tubing into the inflation valve as far as possible see Figure "F". STEP 5 - ROUTE THE ELECTRICAL WIRE All necessary electrical wire and connectors have been included with this Review the electrical schematic before beginning installation see Figure Crimp a blue ring terminal onto the end of the black lead from the compressor. Secure the ring terminal to a grounded component of the chassis. Next, route a length of wire from the pressure switch to a positive 12 volt, 20 amp, ignition activated power source on the vehicle. Cut a length of 16 gauge wire from the 6' length included with this kit. Crimp a blue female terminal connector onto the black lead from the comprssor. Install the female terminal connector over the remaining spade on the pressure switch. Connect the lead from the pressure switch to the 12 volt wire with a wire connector. Slide the wire connector over the existing wire and insert the un-stripped lead from the pressure switch into the wire connector. Close the wire connector over both wires with pliers see Figure "G". Next, install the in-line fuse holder in the positive pressure switch lead. Cut the pressure switch lead near the wire connector and insert the un-stripped ends of the wire into the fuse holder. Close the fuse holder over the wires with pliers and install the fuse see Figure "H". STEP 6 - WIRE THE GAUGE PANEL FOR ILLUMINATION From the...

Descargar ahora

Introduzca dos números de la imagen: