WARNING: Use only the batteries specified above. Use of different batteries than the recommended ones, may have a detrimental effect on the smoke alarm. A good safety measure is to replace the battery at least once a year, or at the same time you change your clocks for daylight saving time. Be sure to follow the battery installation instructions printed on the back of the alarm. NOTE: WEEKLY TESTING IS REQUIRED! NOTE: If after battery replacement the unit continues to chirp, wait for approximate

For this reason, the use of additional smoke alarms for those areas for increased protection is recommended. The additional areas include the basement, bedrooms, dining room, furnace room, utility room, and hallways not protected by the required smoke alarms. The installation of smoke alarms in kitchens, attics (finished or unfinished), or garages is not normally recommended, because these locations occasionally experience conditions that can result in improper operation. 12. Service and Warrant

When products of combustion are sensed, the unit sounds a loud 85db pulsating alarm until the air is cleared. HUSH CONTROL: The “HUSH” feature has the capability of temporarily desensitizing the alarm circuit for approximately 8 minutes. This feature is to be used only when a known alarm condition, such as smoke from cooking, activates the alarm. Models i9060, i9060RV and i9080 are desensitized by pushing the “HUSH” button on the smoke alarm cover. Models i9030, i9040, i9040RV and i9050 are dese

FIGURE 1 FIGURE 2 FIGURE 3 MOBILE HOME INSTALLATION Modern mobile homes have been designed and built to be energy efficient. Install smoke alarms as recommended above (refer to RECOMMENDED LOCATIONS and FIGURES 1 and 2). In older mobile homes that are not well insulated compared to present standards, extreme heat or cold can be transferred from the outside to the inside through poorly insulated walls and roof. This may create a thermal barrier which can prevent the smoke from reaching an alarm m

The red LED (Alarm) will flash the same pattern. WARNING: For alarms equipped with 9V battery backup, when powered by battery backup the alarm will sound and flash only once every conserve battery life. If this unit is interconnected with other Kidde the amber LED (Initiating Alarm) of the unit which first detected the CO, will light and remain on until The other interconnected CO alarms will also alarm to warn you that CO was detected. Fire Alarm Indicator When an interconnected Kidde smoke ala

Red LED Flashes every 30-40 seconds to indicate that the smoke alarm is operating. Test Button Tests unit’s electronic circuitry, horn, and battery function. Description The Kidde 0916E is a battery operated, single station smoke alarm offering the level of protection that you have come to expect in a Kidde product. The Kidde 0916E is designed to alert you and your family to the dangers of smoke and fire. This smoke alarm features an ionization sensor that protects best against fast flaming and

Do not try to repair the smoke alarm yourself. Refer to the instructions in section 12 for service. LOSS OF POWER TO THE ALARM WILL RENDER THIS ALARM INOPERATIVE. 1. Recommended Locations for Smoke Alarms • Locate the first alarm in the immediate area of the sleeping rooms. Try to monitor the exit path as the sleeping rooms are usually farthest from the exit. If more than one sleeping area exists, locate additional alarms in each sleeping area (See figure 3). • Locate additional alarms to monito

This unit can be stored to -10 degrees Fahrenheit without harm to the alarm but it must be above 40 degrees Fahrenheit for use. • Do not place behind curtains or furniture. CO must be able to reach the sensor for the unit to accurately detect CO. • DO NOT locate Alarm within 5 feet (1.5 meters) of any cooking appliance. • Be aware that certain conditions can result in transient CO situations, such as: i) Excessive spillage or reverse venting of fuel-burning appliances caused by: 1) outdoor ambie

Use only the following 9 volt batteries for powering the safety light: Alkaline Type Energizer 522 Duracell MN1604 or MX1604 Gold Peak 1604A Panasonic 6AM6, 6AM-6, 6AM-6PI, 6AM6X and 6LR61 (GA) The safety light has a 6.3 V 250mA fuse lamp with an average life of 50 hours. If the safety light fails to operate with a fresh alkaline battery, then replace the lamp. To replace the lamp, remove the alarm from the mounting bracket by rotating the alarm in the direction of the “OFF” arrow on the cover (