Votos - 2, Puntuación media: 4.5 ( )

Fabricar: Design Dynamics Tamaño del archivo: 2.13 mb Nombre del archivo: Idioma del manual:

CAUTION: You must keep control areas, burners and circulating air passageways of fireplace clean. Inspect these areas of fireplace before each use.Havefireplaceandchimney (if applicable) inspected yearly by a qualified service person. Fireplace may need more frequent cleaningdue to excessive lint from carpeting, bedding material, etc. Only limited cleaning will be required under normal use of this appliance. Dust the front grate and top of receiver/valve. Do not use cleaning fluids to clean logs or any other part of the appliance. If, after a period of use, the flames start to exhibit unusual shapes and behavior or the burner fails to ignite smoothly, then the burner holes may require some cleaning. If this happens, we recommend that you contact your nearest authorized service technician to get the appliance serviced. TRANSMITTER If the battery light is on or the display is blank, you will need to replace the three AAA batteries in transmitter/remoter. To change batteries in the transmitter/remote, slide the battery compartment door off to expose old batteries. Place new batteries into housing and reattach door. See Figure 15. Figure 15 - Bottom of Transmitter, Showing Battery Compartment and Door TECHNICAL SERVICE You may have further questions about installation, operation or troubleshooting. If so, contact DESA.s Technical Service Department at 1-866-672-6040. When calling please have your model and serial numbers of your heater ready. You can also visit DESA.s technical services web site at REPLACEMENT PARTS Note: Use only original replacement parts. This will protect your warranty coverage for parts replaced under warranty. PARTS UNDER WARRANTY Contact authorized dealers of this product. If they can.tsupply original replacementpart(s),callDESA.s Technical Service Department at 1-866-672-6040. When calling DESA, have ready • your name and address • model and serial numbers of your log set • how log set was malfunctioning • type of gas used (propane/LP or natural gas) • purchase date Usually, we will ask you to return the part to the factory. PARTS NOT UNDER WARRANTY Contact authorized dealers of this product. If they can.t supply original replacement part(s), call DESAat 1-866-672-6040 for referral information. When calling DESA, have ready • model number of your log set • the replacement part number 115481-01B TROUBLESHOOTING Note: In normal operation, LED blinks once every two seconds; also, LED will be on for one second after every valid command received by the receiver/valve' these are not error codes. Failure codes can occur anytime after the pilot burner is lit. Failure code timing is 1/4 second on, 1/2 second off. Sequence is failure code followed by LED not blinking for four seconds. In the event of multiple failure codes, the next failure code follows the previous failure code by approximately 3 seconds. LED Failure Code (No. of Blinks) Service Action 8 Replace valve. 7 Confirm stepper motor connection exists. 5 Confirm fan connection exists and works. 3 Replace thermopiles. 2 Devicetoohot.Turnonfan orifapplicable,openglass doors. 1 short blink Normal operation LED Fail...

Descargar ahora

Introduzca dos números de la imagen: