Votos - 3, Puntuación media: 3 ( )

Fabricar: Browning Tamaño del archivo: 813.27 kb Nombre del archivo: Idioma del manual:

Air must circulate through your safe or condensation will form on your firearms causing rust. Loosen the door just enough to allow some exchange of air. An electric dehumidifier is highly recommended if your average daily relative humidity is above 20 percent. hinges figure 5 Your door height is adjusted at the factory and should not require any adjustment when new. However, hinge adjustment bolts are located on the bottom of each hinge to allow you to make adjustments over time (Figure 5). This allows you to raise and lower the door slightly as needed. Rotating the Allen bolt counterclockwise (looking down at the hinge) raises the door on its hinges. Both Allen bolts (top and bottom hinges) should be turned the same amount when adjusting the door. (Not applicable on Compact Series safes.) shear Pin The handle shaft of some safe models is attached to the locking mechanism with a shear pin. The shear pin will snap if excessive force is applied to your safe handle (approximately 175 ft/lb.). This feature provides additional security against attempted break in. If the shear pin is broken, the handle will spin within the safe door and you will not be able to open your safe. Contact the Browning ProSteel Safe Warranty Service line toll free at (877) 501-7233, ext. 14 for assistance with replacement of the handle shear pin. shelf adJustment Prior to adjusting any shelf, first remove all items from that shelf. Your shelves are held in place by several clips that secure them to four “tracks” on the safe interior. Some are above the shelves and some are below. To remove a clip, squeeze it together with hand pressure or adjusting the hinges. pliers and lift up. The shelves can be relocated along this track by simply relocating the clips to the desired shelf location. To replace a clip, insert the top lip of the clip into the appropriate slot in the track, squeeze the clip together and insert the bottom lip of the clip into the track. It is important that all clips supporting a particular shelf are located at the same height to ensure that the shelf sits level. Notice! The gun rack is fragile and can easily be broken when aTTempTing To remove iT or insTall iT in a new locaTion. do noT aTTempT To remove The gun rack by forcing iT ouT of The reTainer clips. remove all Top clips before aTTempTing To move The gun rack. supporT The enTire widTh of The gun rack before removing iT. faCtory installed interior lights Some safes include a factory-installed interior light package located in the ceiling of the safe. The inTerior lighT bulbs are hoT. To reduce The risk of fire, damage, or injury please noTe The following: • BulB gets hot quickly. Do not touch lens, guarD or enclosure. Touch only The power swiTch/plug when Turning on. • keep comBustiBles away from interior lights. • Do not operate the lights if DamageD, without the compleTe bulb (lamp) enclosure in place or if bulb enclosure is damaged. • Do not look Directly at lighteD BulB. • keep all items at least 3"...

Descargar ahora

Introduzca dos números de la imagen: