Votos - 4, Puntuación media: 4 ( )

Fabricar: Browning Tamaño del archivo: 813.27 kb Nombre del archivo: Idioma del manual:

6 Use a 2" wood bit to drill though the fire-resistant insulation. Do not attempt to drill through the steel safe body with the wood bit. 7 Reposition the safe on your centerline marks against the wall and mark the hole centers on the wall of the house. 8 Use a 5/16" wood bit to drill the pilot holes through the sheet rock and stud. Next install 3/8" x 3." lag bolts through a 1." diameter steel washer through the safe body and into the stud. Tighten all anchor bolts. 9 Fill the 2" holes in the safe interior with high-temperature silicone caulking and reposition the carpeting “X” cut out. The caulking will hold the carpet in place. oPerating the (dial) ComBination loCk oPening the safe 1 Turn the dial counterclockwise (left) four times, passing the first number in your combination three times and stopping on it the fourth time. 2 Turn the dial clockwise (right) three times, passing the second number in your combination two times and stopping on it the third time. 3 Turn the dial counterclockwise (left) two times, passing the third number in your combination once and stopping on it the second time. 4 Turn the dial clockwise (right) until it stops, which is normally around 95. 5 Turn your safe handle clockwise to open the safe door. IMPORTANT: If you miss any combination number by more than 1 dial mark your safe will not open. Make sure you are looking straight down at the index marks. Make sure to align the numbers with the center index line located at the 12 o’clock position. If the safe does not open, try turning the safe handle firmly counterclockwise before re-dialing the combination. loCking the safe 1 Close the door with the locking bolts retracted. 2 Turn the safe handle counterclockwise (left) to extend the bolts into the door frame after the door is closed. 3 Turn the combination dial counterclockwise (left) at least three times to lock the bolts in place. IMPORTANT: You must first close the door and then turn your safe handle counterclockwise to extend the bolts before turning the dial to properly lock the door in place. If the dial is turned while the door is open and the bolts are extended (handle turned clockwise) the door will be “locked open.” This is easily fixed by following the unlocking procedure previously mentioned, immediately followed by the locking procedure listed above. To prevenT someone from inadverTenTly becoming locked inside your safe, always keep your safe in a locked condiTion, even if your valuables are noT inside. failure To do so could resulT in serious injury or deaTh. eleCtroniC loCks If your safe is equipped with a factory installed electronic lock, instructions for the lock are inside the safe. No maintenance is required for the electronic lock, other than changing the battery by following the directions in the lock instructions. 14 You should immediately change the combination of the electronic lock from the factory default code. The lock instructions outline the process to program a new electronic lock comb...

Descargar ahora

Introduzca dos números de la imagen: