Votos - 0, Puntuación media: 0
(
)
)
|
Otros manuales para este modelo:
Resumen del manual
Hardware and Software Installation Procedure
This document is for software version 7.2.17.0. These instructions apply to the A9899A-
60001 (1000Base-SX--fiber-based) and A9900A-60001 (1000Base-T--copper-based) PCI-X
gigabit Ethernet cards on Windows Server 2003, 64-bit and Linux. The Base-T cards
operate at 10 or 100 Mbit/s in either full- or half-duplex modes and at 1000 Mbit/s only in
full-duplex mode. The 1000Base-SX cards operate only at 1000 Mbit/s and in full-duplex
mode. Ensure that you set both your switch and gigabit Ethernet card to auto negotiation or
set both to the same speed and duplex mode. Wake-on-LAN is supported only on port A
(see Figure 1) of each core AB352A Base-T card and only when used on certain Itanium-
based systems. The LAN card driver is on the HP Smart Setup Build 2.0 (or later)
application CD. It is also downloadable at http://www.hp.com/support/itaniumservers. Note:
you will not need to perform the following hardware and software installation steps if your
Gigabit Ethernet card was factory installed (ordered on product option 0D1) or its LAN port
is the “built-in” or “core” LAN.)
Installing HP Server 1000Base-TX/SX PCI-X LAN Adapters
(P/N A9899A/A9900A)
Step 1: Access the system card bay
NOTE: To obtain updates to driver e1000645.sys (version 7.2.17 or later), please check HP
Driver Support on http://www.hp.com/support/itaniumservers
Shut down the HP Server, unplug the power cord and remove the cover(s). Refer to system
documentation for instructions on server shut down procedures and cover removal.
Turn off and unplug the power to the HP Server before removing its cover. Failure to do so
could inflict a dangerous shock to you and may damage the adapter or HP Server.
• Wait for the system to shut down completely, and then power off the system by pressing
the system off button. Ensure that the system is grounded.
• Open the system to gain access to the PCI backplane.
• Select an empty PCI or PCI-X slot and remove the slot cover. The card can operate in
PCI as well as PCI-X mode.
Step 2: Install the card
• Observe the antistatic precautions. HP recommends wearing ESD straps when
installing the card.
• Record the serial number and MAC address located on the card for future reference.
7
HP CONFIDENTIAL Codename: Mt. Diablo/Orca Part Number: Last Saved On: 2/11/04 2:01 PM DRAFT COPY
...Otros modelos de este manual:
Software - Microsoft Windows Server 2008 for Itanium-based Systems (220.71 kb)