Votos - , Puntuación media:
(
)
)
Fabricar: Earlex
Tamaño del archivo: 489.87 kb
Nombre del archivo: asg55.pdf
Idioma del manual:
El documento se está cargando, por favor, espere
 |
El documento se está cargando, por favor, espere
Resumen del manual
Earlex Ltd will accept no responsibility for the use of this product if usedfor any other purposes than those detailed herein. SAFETY OPERATING INSTRUCTIONS WARNING: When using the Paint Sprayer, basic safety precautions, including the following, should always be followed t< reduce the risk of fire, electric shock and personal injury ! Keep work area clean -Cluttered areas and benches invite injuries. ! Consider work area environment -Do not expose the spray gun to rain. Do not use the spray gun in damp or wet locations. Keep work area well lit. ! Guard against electric shock -Avoid body contact with earthed or grounded surfaces (e.g. pipes, radiators, ranges, refrigerators). ! Keep children away from the spray gun. ! When not in use, paint sprayer should be stored in a dry, high or locked place, out of reach of children. ! Use the paint sprayer for the job it was designed for only. Mis-use of the spray gun will invalidate the guarantee. ! Dress properly -do not wear loose clothing or jewellery, they can be caught in moving parts. Rubber gloves and non-skid footwear are recommended when working outdoors. Wear protective hair covering to contain long hair. ! Always wear a mask when spraying. ! We recommend the use of eye protection to keep hazardous vapours out of eyes. ! We recommend the use of ear protectors. ! Do not abuse the cord -Never carry the tool by the cord or pull it to disconnect it from the socket. Keep the cord away from heat, oil and sharp edges. ! Do not overreach -Keep proper footing and balance at all times. ! Always disconnect from mains supply when not in use, when refilling the paint container and before cleaning. ! Avoid unintentional starting, do not carry a plugged in tool with a finger on the switch. ! When tool is used outdoors, use extension cords only intended for outdoor use. ! It is recommended that a RCD (residual current device) rated at 30mA is fitted into the mains supply socket for added protection against electric shock. ! Stay alert -Watch what you are doing. Use common sense and do not operate tool when you are tired. ! Never under any circumstances aim the nozzle at another person or animal. In the event of injury occuring seek expert medical advice immediately. ! Always keep the spray nozzle in place during use. Never allow the spray nozzle to come in direct contact with the skin. ! Always ensure there is adequate ventilation when spraying. ! Never spray near a source of ignition, e.g. hot surfaces, sparks, cigarettes, glowing wires ! open flames including appliance pilot flame. ! The paint sprayer must not be used for spraying flammable materials having a flash point below 21.C. ! Always beware of any hazards presented by the material being sprayed and consult the markings on the container or the information supplied by the manufacturer of the material to be sprayed, including requirements for the use of personal protective equipment. Do not spray any material where the hazard is not known. ! The paint sprayer must not be cleaned with flammable liquids having a flash point below 21.C. ! Check for damaged parts -Before further use of the paint sprayer, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment of moving parts, free running of moving parts, breakage of parts, mounting and any other conditions that may affect its operation. A guard or other part that is damaged should be properly repaired or replaced by an authorized service centre unless otherwise indicated in this instruction manual. Have defective switches replaced by an authorized service facility. Do not use the tool if the switch does not turn it on and off. ! Warning -The use of any accessory or attachment, other than those recommended in this instruction manual, may present a risk of personal injury. ! Maintain tools with care -Follow instructions for lubrication and changing the accessories, inspect tool regularly and if damaged, get repaired by an authorized service centre. ! Have your tool repaired by a qualified person – This electric tool is in accordance with the relevant safety requirements. Repairs should only be carried out by qualified persons using original spare parts, otherwise this may result in considerable danger to the user. ! Do not spray any material where the hazard is not known. ! Use genuine Earlex parts only. ! This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. NOISE AND VIBRATION LEVELS The following values were measured in accordance with EN50144-2-7 A-weighted sound power level: 99.9dB(A) Vibration level: 8.824 m/s2 2 1/23c4PARTS AND ACCESSORIES 53a3b671/23c4PARTS AND ACCESSORIES 53a3b67 1. 1.0mm Nozzle SG209 4. Suction Tube and F...