Votos - 3, Puntuación media: 4.7
(
)
)
|
Resumen del manual
Remove it by turning CLOCKWISE! IMPORTANT To install a trimmer head onto a brushcutter unit, first remove the shaft bolt and bolt guard. 1. Position the gearcase with the output shaft facing up and remove both holders. 2. Position Holder A as shown and slide it onto the gearcase shaft. 3. Install and center the safety clip on the gearcase shaft. 4. Install Holder B on the gearcase shaft. The machined boss on Holder A must engage with the recess on Holder B. 5. Rotate the gearshaft and holders until the hole in Holder A aligns with the matching hole in the gearcase flange, and then lock the holder to the gearcase by inserting the long end of the hex wrench through both holes. Install Holder A Slide Holder A onto the gearcase shaft 6.Using a counter-clockwise rotation and hand pressure alone, thread and securely tighten the trimmer head into the gearcase shaft. 7.Remove the hex wrench from the gearcase and holders. The unit should now be completely assembled and ready for use with a trimmer head. Install Holder B SafetyClip Position safety clip and install Holder B Hex Wrench Hand-tightentrimmer head Securely tighten the trimmer head into the gearcase shaft using hand-pressure Assembly (continued) Installing Brushcutter Blade Turn the unit upside down so the gear case 1. output shaft is facing UP and remove the shaft bolt, bolt guard and holder B from the gear case shaft. Align the hole in blade holder A with the2. matching hole in the gear case flange and then temporarily lock the out- put shaft by inserting a hex wrench through both holes. Slide the safety clip off-center 3. Fit the blade over the safety clip and then4. center it over the flange on holder A. Lock the blade in place by centering the safety clip on the output shaft. CAUTION! Install the blade so its printed surface is visible to the operator when the brushcutter is in the normal operating position. WARNING! ...................................................................................................................................... hole must be centered over the raised boss on blade Holder A. WARNING! ............................................................ the blade and the splines engaged to the output shaft. Install blade holder B on the output shaft.5. The recess in the holder must completely cover the safety clip, and must fit tightly against the blade. Install the bolt guard and then the blade 6. retaining bolt. Using the combination spark plug wrench/screwdriver, tighten the bolt firmly in a counter-clockwise direction. Remove the hex wrench. 7. WARNING! Do not attach any blade to a unit without proper installation of all required parts. Failure to use the proper parts can cause the blade to .................................................................................. and/or bystanders. The unit should now be completely assembled and ready for use with a blade. IMPORTANT! Slide the safety clip off-center Slip the Saw BladeIn ...
Otros modelos de este manual:Herramientas de jardín - 89304 (1.76 mb)
Herramientas de jardín - 89304 (1.76 mb)
Herramientas de jardín - 89304 (1.76 mb)
Herramientas de jardín - 89304 (1.76 mb)