WIRING DIAGRAM INSTALLATION This wall switch can be used for either single pole or multiswitch installation. A multiswitch installation with an electronic wall switch differs from conventional installation. Read wiring instructions carefully. Use guidelines applicable to your installation. Apply the following steps for all installations. Note: The black wall switch wires have no polarity. You can use any of them. 1. Interrupt power at circuit breaker to avoid electric shock. 2. Take out and disc

• Installation • Cut power at the circuit breaker to avoid electric shock. • Remove the existing switch. (For a 3-way installation, identify and label the wire that is connected to the “common” screw.) • Install the new switch (refer to the appropriate section below). • Apply power at the circuit breaker. NOTE A: The white wire is not the neutral wire but the wire going to the load. SINGLE-POLE INSTALLATION 120 VAC Neutral Line See NOTE A 120 VAC Line Neutral Connect wires "2" and "C" of TI034-3

Esta garantia no cubre los costos de desinstalacion y reinstalacion. Esta garantia no sera valida si se demuestra que el defecto o el mal funcionamiento se deben a un dano que ocurrio cuando el producto estaba en posesion del consumidor. La unica responsabilidad de AUBE sera la de reparar o reemplazar el producto de acuerdo con los terminos aqui establecidos. AUBE NO SERARESPONSABLE DE NINGUNA PERDIDA NI DE NINGUN DANO DE NINGUN TIPO, INCLUIDOS LOS DANOS IMPREVISTOS O DERIVADOS QUE RESULTEN, DIR