Depending upon the location of the unit, it may be necessary to change the side on which the dryer door opens. DC68-01052A
MCS Part no. 1 12001702 6 22002782 2 22002966 2 216423 1 22001817 1 16010016 Description Plastic Plugs (Pkg. Of 2) Foam Pads (Cabinet to base vibra U-Nuts (Front panel vibration) Screws, Console to Top Cover Asphaltic Pad Instruction Sheet Although vibration is attributed to unlevel appliances or weak flooring, the components of this kit are put together to aid the service technician in the home when addressing loose cabinet metal to baseframe and front pane! vibration. First identify
Therefore, before assuming a motor needs to be replaced, the following areas should all be checked and the appropriate service done. 1. Clean and lubricanrtne motor carriage. The motor carriage should be lubricated with Maytag Poly Lube Grease, Part No. 2-4999 or 2-3959. j 2. Check for a broken or missing motor carriage roller(s}. If a roller is broken, a 2-5000 motor roller repair kit should be used. 3. The Maytag washer isydesigned to operate on an individual 15 afltfflr branch circuit supp
11 wire from the signal lamp assembly. Unsnap and discard the ON Light lamp assembly. 4. Fold the Black No. 3 wire back and tape the wire to the main harness out of the way. 5. Locate and remove connector P7 from the left side of the Machine Control board. 6. insert the jumper wire (Red Wine No. 3), found in the service repair assembly, into position number 5 of the P7 connector, then reconnect the P7 connector back onto the Machine Control Board. 7. Remove the Yellow based indicator lamp
Remove the double back tape and firmly attach the stacking kit the top of the washer to assure the proper seal. Make sure the word FRONT printed on the stacking kit is facing forward as shown above. 3) Put back edge of stacking kit to back mold line of washer's top cover and tighten the screw. 6) Gently push the dryer into position as indicated in figure 5 & 6, sliding the unit into the slots provided. It is important that the dryer is level. Make sure all four leveling legs are pushed all