Votos - 4, Puntuación media: 4
(
)
)
|
Resumen del manual
Remove cleanser residue before drying the next load. Every 18 months an authorized servicer should clean the dryer cabinet interior and exhaust duct. These areas can collect lint and dust over time. An excessive amount of lint build-up could result in inefficient drying and possible fire hazard. Outside • Clean the cabinet with mild soap and water. Never use harsh, gritty or abrasive cleansers. If the cabinet becomes stained, clean with diluted chlorine bleach [1/2 cup (120 ml) in 1 quart (.95 liter) water]. Rinse several times with clear water. Remove glue residue from tape or labels with a mixture of warm water and mild detergent. Or, touch residue with the sticky side of the tape or label. Before moving the dryer, place a strip of cardboard or thin fiberboard under the front leveling legs to prevent damage to floor. Before calling for service, review this list. It may save both time and expense. The list includes Avoid Service common occurrences that are not the result of defective workmanship or materials in this dryer. Checklist OCCURRENCE POSSIBLE CAUSE SOLUTION Dryer does not start. Electrical power cord is not securely plugged Make sure the plug fits tightly in wall outlet. in or plug may be loose. House fuse blown or circuit breaker tripped. Reset circuit breaker or replace fuse. Make sure electrical line is not overloaded and the dryer is on a separate circuit. Thermal limiter tripped. Call authorized service person for replacement. Dryer runs but won't heat. There are 2 house fuses in the dryer circuit. Replace fuse. If 1 of the 2 fuses is blown, the drum may turn but the heater will not operate. Gas supply valve is not open (gas models). Checkto make sure supplyvalve is open. SeeINSTALLATION INSTRUCTIONSfor procedure. Dryer does not have anough air supply to See INSTALLATION INSTRUCTIONS. support the burner flame (gas models). LPgassupplytankisemptyorthere hasbeen Refill or replace tank. a utility interruption of natural gas (gas models). Dryer should heat when utility service is restored. Drying cycle takes too long, Lint screen is clogged with lint. Make sure all lint has been removed from the dryer lint outside of the dryer feels screen before starting each cycle. too hot or smells hot. Exhaust duct requirements have not been Exhaust duct must be at least 4 inches in diameter and made met. of rigid or flexible metal. When in place, the duct must have no more than two 90 ° bends and must not exceed length listed in INSTALLATION INSTRUCTIONS. Electric dryer is connected to a 208 volt Drying time will be 20% longer than drying on a 240 volt circuit, circuit. Drying procedures have not been followed. See Drying Procedures, page 4. Outside exhaust hood or exhaust duct may Clean out any obstruction. be clogged or restricted. High humidity. Use a dehumidifier near the dryer. Excessive wrinkling. Dryer is overloaded. Do not overload. See Drying Procedures, page 4. Items left in dryer too long. Remove items as soon as cycle ends. Insufficie...
Otros modelos de este manual:Secadoras - P/N 131883600 (9907) (618.61 kb)
Secadoras - P/N 131883600 (9907) (618.61 kb)
Secadoras - P/N 131883600 (9907) (618.61 kb)
Secadoras - P/N 131883600 (9907) (618.61 kb)