Votos - 6, Puntuación media: 4.5
(
)
)
|
Resumen del manual
• The dryer will not start if the cycle selector is in the OFFposition. 7. When the cycle ends, remove items immediately and hang Fill dryer drum 1/3 to 1/2 full. or fold. If load is removed before the cycle ends, turn cycle selector to OFF. Features Placethe front bar under the lip of the lint screen opening. Cycle Signal Control (some models) When the Cycle Signal Control is ON, a signal will sound at the end of each cycle and during the Fabric Sentry setting (some models). The volume is adjustable on some models. Drum Light (some models) A drum light will come on whenever the door is opened to illuminate the dryer drum during loading and unloading. Closing the door turns off the light. Reversible Dryer Door Your dryer is equipped with a reversible door. The door can be hinged on the right or left side. Refer to the INSTALLATIONINSTRUCTIONSfor directions on changing the door. Drying Rack (some models) Usethe drying rack to dry items which should not be tumble dried. 1. Open the dryer door and remove the lint screen. 2. Insert drying rack into the dryer drum. Place the front bar under the lip of the lint screen opening. 3. Place items to be dried on top of the rack. Weight should not exceed 10 Ibs. Leavespace between items, but do not let items hang over the sides or through the grids. Do not tumble other items when using the drying rack. 4. Select atimed drysetting best suited for items being dried. Useonlythe Air Fluff (no heat) temperature setting for items containing plastic, foam rubber, rubberlike materials, feathers or down. 5. When items are dry, remove the rack and replace the lint screen. If lint screen is not in place, tumbling items could enter the exhaust system and cause damage to the dryer. Common Drying Problems Many drying problems involve poor cleaning results, poor soil and stain removal, residues of lint and scum, and fabric damage. For satisfactory drying results, follow these suggestions provided by The Soap and Detergent Association. PROBLEM Greasy, oily stains Lint Pilling (Fibers break off, ball up and cling to fabric.) Shrinking POSSIBLE CAUSES • Fabric softener sheet. Overloading. Overdrying causes static electricity. Lint screen not clean when cycle began. Lint is attached to "pills." • Pilling is normal with synthetic and permanent press fabrics. This is due to abrasion from normal wea r. • Overdrying. Wrinkling • Overloading. • Leaving items in dryer after cycle ends. SOLUTIONS • Rub fabric softener stains with bar soap. Rinse and rewash, • Reduce load size and rewash using liquid fabric softener in the final rinse. • Or, add a fabric softener sheet and tumble without heat. • Use lint brush or roller to remove lint. • Use a lint brush or shaver to remove pills. • Irreversible condition. • Reduce load size and tumble at medium or low heat for 5-10 minutes. • Remove items immediately. Hang or fold. PREVENTIVE MEASURES • Add a few bath towels to small loads for proper tumbling. • Some "silk-like" fabrics should be air ...
Otros modelos de este manual:Secadoras - P/N 131883600 (9907) (618.61 kb)
Secadoras - P/N 131883600 (9907) (618.61 kb)
Secadoras - P/N 131883600 (9907) (618.61 kb)
Secadoras - P/N 131883600 (9907) (618.61 kb)