Votos - 0, Puntuación media: 0
(
)
)
|
Otros manuales para este modelo:
Resumen del manual
6.
Remove the top access cover.
Verifying component failure
a.
Lift the access panel latch (1). The access panel will slightly
disengage from the enclosure.
Improper or failed operation of the LEDs on the power UID may indicate
b.
Slide the access panel to the rear (2) and lift away from the
a replacement is necessary.
chassis.
•
= Health. Solid green indicates the enclosure is operating
normally. Blinking green indicates that the enclosure is starting up
and not ready, performing POST. Off indicates that there is no power.
•
= Fault warning. Flashing amber indicates a fault of lesser im-
portance, while solid amber indicates a fault of greater importance.
•
= Unit identification. Push button to illuminate solid blue; push
again to turn off. The UID mimics the status of the UID at the front of
the enclosure. A remote session from the management utility can also
illuminate this LED.
•
= Bi-color On/Standby button. Green indicates power is applied,
while amber indicates standby power.
NOTE:
A Torx tool with T-10 and T-15 ends is provided inside
the enclosure chassis, on top of the I/O module
Removing the power UID and
housing.
interconnect board
1.
Schedule a maintenance window.
7.
Remove cable from the power UID board (1).
2.
Stop all I/O to the enclosure.
3.
Power down the enclosure by pressing and holding the On/Standby
button on the rear of disk enclosure, until the system power LED
changes from green to amber.
4.
Remove all cabling from the external enclosure components. Ensure
all cabling is marked to facilitate recabling later.
WARNING!
A disk enclosure fully populated is heavy. Prior to
removing the enclosure from the rack, remove each
disk and label it with its bay number. Place each disk
on a clean surface. If this is not possible, two people
are required to remove the enclosure from the rack to
prevent injury.
8.
Remove the T-15 screw securing the LED bezel ring and interconnect
board to the enclosure (2).
5.
Loosen the thumbscrews that secure the enclosure to the front of the
rack, and remove the enclosure from the rack.
9.
Remove the LED bezel (3) and interconnect board (4).
Page 2
...Otros modelos de este manual:
datos de dispositivos de procesamiento - HP D2600 Disk Enclosure/S-Buy (103.92 kb)
datos de dispositivos de procesamiento - HP D2600 w/6 2TB 6G SAS 7.2K LFF DP MDL HDD 12TB Bundle (103.92 kb)
datos de dispositivos de procesamiento - HP D2600 w/6 3TB 6G SAS 7.2K LFF Dual port MDL HDD 18TB Bundle (103.92 kb)
datos de dispositivos de procesamiento - HP D2600 w/6 450GB 6G SAS 15K LFF Dual Port Enterprise HDD 2.7TB Bundle (103.92 kb)