Votos - 4, Puntuación media: 4.8 ( )

Fabricar: Frigidaire Tamaño del archivo: 460 kb Nombre del archivo: Idioma del manual:

CAUTION: Do not force the light housing off the mirror. This may damage the mirror (e.g. chipping, cracking, etc.) 2. Remove screws from each side of housing. 3. Carefully reach into the housing and remove spring clip. Hold socket and pull out the old bulb. 3. Hold socket and push in new bulb (DO NOT exceed wattage). Replace spring clip. 4. Set aside until all bulbs have been changed. Figure 6 - Removing Housing and Top Contrasting Bulb Screw Housing Mirror Front of Stove 117190-01B CLEANING AND MAINTENANCE Continued Replacing Log Set Ember Bed Bulbs 1. Carefully remove mirror from unit by lifting it gently from the stove. Store in a safe place or lay it face down on the carpet. 2. From the bottom, lift up the log set ember bed and remove it from the unit (do not pull up on logs). 3. Remove spring clip from bulb. Hold socket and pull out old bulb. 4. Hold socket and push in new bulb. Replace spring clip. 5. Repeat steps 2 and 3 for the second bulb. Figure 7 - Ember Bed Bulb Replacement (Looking in from Top of Unit) Log Grate Bulb with Spring ClipBulb with Spring Clip Replacing Flame Generation Bulbs 1. Unscrew the 6 screws from back of stove shown in Figure 8. Remove metal plate. AVOID STRESS TO THE WIRES. Figure 8 - Locating Flame Generation Cylinder Grounding Connecting Screw Screws Screws Screws 2. Locate the flame generation cylindrical drum. It is constructed of two removable halves; either of which can be removed from the unit. 2. Squeeze half of drum cylinder until it's top edge clears the top drum track. Remove bottom edge of cylinder drum from bottom drum track. This will give you access to the light bulbs. Note: Do not exert excessive pressure on drum cylinder as this may cause damage. 3. Remove spring clip. Hold socket and pull out old bulb. 4. Hold socket and push in new bulb (DO NOT exceed wattage). Replace spring clip. 5. Repeat steps 5 and 6 for second bulb. 6. Insert bottom edge of removed cylinder half into bottom drum track. Gently squeeze drum cylinder until it's top edge fits into top drum rack. 7. Replace the metal plate with screws. 8. Replace the log set ember bed. 9. Replacethemirror. Note:Beforereplacing,clean mirror of any dust or fingerprints. Make sure the mirror side is toward the front of the unit. 10. Replace the top contrasting light housing. Note: The contrasting light should be placed at the mid point of the mirror edge. 11. Replace the metal plate and 4 screws. Replace the top of the unit by sliding the top forward until the clips reconnect. 12. Secure the top to the back frame by reattaching screws. Flame Cylinder Drum Figure 9 - Flame Generation Cylinder Drum 117190-01B 7 CLEANING AND MAINTENANCE Continued CLEANING FRONT PANEL GLASS WARNING: When cleaning unit, the power supply should be disconnected and the unit should be cool. Over time the front glass panel may become dirty or dusty. Dust can be removed by lightly rubbing the glass surface with a clean, lint free cloth or p...

Descargar ahora

Introduzca dos números de la imagen: