Thereafter, change oil after every 50 hours of operation. Change the oil while the engine is still warm. The oil will flow freely and carry away more impurities. Make sure the engine is level when filling, checking or changing oil. Change the oil as follows: • To keep dirt, grass clippings, etc. out of the engine, clean the area around the drain plug and plug before removing it. • Remove the oil drain plug and dipstick. Tilt the engine slightly towards the oil drain to obtain better drainage. Be

Begin by removing the oil dipstick and plug. Start pouring the oil in slowly. The engine will hold approximately 26 ounces of oil. To 'heck the oil, clean and replace the dipstick. Do not ^crew the dip stick in when checking the oil level. Next, remove the dipstick to check the level. The oil dipstick is clearly marked with lines that tell you when the engine has enough oil. Do not fill above this point. NOTE: When adding oil to the engine crankcase, use a high quality detergent oil classified

Make sure fuel cap is secured tightly and check engine for fuel leaks before starting engine. Move generator away from refueling area or any spillage before starting engine. Allow for fuel expansion. Keep maximum fuel level . inch below the tip of the fuel tank. Never refuel with the engine running. MGP-670070 5 — ENG READ AND UNDERSTAND ALL WARNINGS BEFORE Risk of Injury and Property Damage When Transporting Generator HAZARD WHAT COULD HAPPEN HOW TO PREVENT IT Fire, Inhalation, Damage to Vehicl

8 a.m, to 5 p.m (CST) CAUTION: Read and Follow all Safety Rules and Instructions Before Operating This Equipment ® 120-240 VOLT / 8000 WATT A-C DELUXE PORTABLE GENERATOR -Assembly ° Operation • Customer Responsibilities . Service and Adjustment o Repair Parts SEARS, ROEBUCK and CO., Hoffman Estates, IL 60179 U.S.A. SAFETY RULES CAUTION: ALWAYS DISCONNECT SPARK PLUG WIRE AND PLACE WIRE WHERE IT CANNOT CON-,_ TACT SPARK PLUG, TO PREVENT ACCIDENTAL STARTING WHEN SETTING UP, TRANSPORTING, ADJUSTING

•Remove gas cap. Use clean, fresh, regular unleaded gasoline with a minimum of 85 octane. Do not mix oil with gasoline. Never fill fuel tank completely. Fill tank to 1/2" below the bottom of the filler neck to provide space for fuel expansion. Wipe any fuel spillage from engine and equipment before starting engine. • Do not overfill. Never fill fuel tank indoors. Never fill fuel tank when engine is running or hot. Do not smoke when filling fuel tank. To Start Your Generator Never run engine indo

HELPLINE -\\ I-soo-===-3136 120 VOLT / 2500 WATT • Assembly HOURS: l Mon. -Fri. 8 a.m. to 5 p.m • Operation (CST) I • Customer Responsibilities CAUTION: ' ° Service and Adjustment LRead and Follow all SafetyRule s L L • Repair Parts __ andlnstructions Before Operating This Equipment ...........L. SEARS' ROEBUCK and CO., HoffmanEstates,..tL _ 60179U,S,A, Part No. 99372 Revision I (4/2/96) SAFETY RULES TACT SPARK PLUG, TO PREVENT ACCIDENTAL STARTING WHEN SETTING UP, TRANSPORTING, _ AUTION: ALWAYS

Protected by a 25 amp circuit breaker. FULL POWER SWITCH – Switch used to convert every receptacle on the panel, when placed in the 120 position, to a 120 volt receptacle. This will allow you to receive the full capacity of the generator by using all 120 volt receptacles. When in the 120/240 position, you will only be able to use half of the 5800 watts when using the 120 volt receptacles. But in this position, the full 5800 watts can be received in the 240 twistlock receptacle. AIR CLEANER- Incl

Compare this illustration with your generator to familiarize yourself with the location of various controls and adjustments. Save the manual for future references. FUEL CAP 120 VOLT RECEPTACLES 240 VOLT RECEPTACLI circuit breaker: FUELTANK ENGINE RUN/STOP SWITCH AIR CLEANER CHOKE SWITCH ENGINE OIL FILL FUEL TANK- Capacity of 7 US gallons. CHOKE SWITCH- Lever used to start cold engine. ENGINE RUN/STOP SWITCH- Sets engine in starting mode for recoil starter - Stops running engine. ENG

This warranty gives you specific legal rights and you may also have other rights, which vary from PROVINCE TO PROVINCE. Sold by Sears Canada, Inc., Toronto, Ont. 2 - ENG SAFETY GUIDELINES - DEFINITIONS This manual contains information that is important for you to know and understand. This information relates to protecting YOUR SAFETY and PREVENTING EQUIPMENT PROBLEMS. To help you recognize this information, we use the symbols to the right. Please read the manual and pay attention to these se

Removal of guarding could expose elec= trically charged components and result in electrocution. HOW TO PRI:VENT iT Operate generator in a clean, dry, well ventilated area. Make sure hands are dry before touching unit. Inspect extension cords before use and replace with new if required. Use proper size (wire gauge) cordset for application. Always use electrically grounded cordset. Place generator on low conductivity surface such as a concrete slab. Read the load rating chart and instructions on p